Installing the wine conditioning unit. Miele KWT 6322 UG, 10028620

Add to My manuals
80 Pages


Installing the wine conditioning unit. Miele KWT 6322 UG, 10028620 | Manualzz



Installing the wine conditioning unit

Before installing the wine conditioning unit

 Take any accessories out of the appliance.

To install the wine conditioning unit, you will need the following tools:

– A selection of screwdrivers

– a spirit level

– a tape measure

The following installation parts are required:

– Ventilation grilles

– Air filter

– Foam block for air filtration in the appliance plinth

– Screws to secure the appliance in the niche

– Wrench to adjust height in the niche

 Remove the cable clip from the back of the appliance (depending on model).

 Risk of damage and injury from the wine conditioning unit tipping over.

There is an increased risk of injury and damage if the wine conditioning unit is installed by a single person.

Two people are required for installing the wine conditioning unit.

 Install the wine conditioning unit in a stable, solid housing unit, positioned on an even and level floor.

 The building-in niche must be horizontally and vertically aligned.

 The required ventilation gaps must be provided (see “Ventilation” and “Installation dimensions” under “Installation”).



Key Features

  • Built-in Compressor wine cooler 34 bottle(s) Number of temperature zones: 2 Black
  • Number of shelves: 4 Number of doors: 1
  • 35 dB
  • 146 kWh
  • Interior light Temperature alarm

Related manuals


Table of contents