Securing the wine conditioning unit in the niche. Miele KWT 6322 UG, 10028620

Add to My manuals
80 Pages

advertisement

Securing the wine conditioning unit in the niche. Miele KWT 6322 UG, 10028620 | Manualzz

*INSTALLATION*

Installation

Securing the wine conditioning unit in the niche

 The wine conditioning unit must protrude evenly from the furniture doors by 1/16" (2 mm).

 Open the appliance door.

 Remove cover   and first screw the wine conditioning unit to the adjacent furniture unit at the top left   .

The wine conditioning unit will align itself to the left side of the niche. The front of the appliance door must be flush with the furniture front.

 Put cover   back into place.

 Screw the wine conditioning unit at the bottom right and left to adjacent furniture units.

 If necessary, a fourth screw can be used in the top right-hand hinge to secure the wine conditioning unit.

To do so, dismantle the door and then fit this extra screw.

 Close the appliance door and check that the side edges of the appliance door are aligned with the side walls of the wine conditioning unit.

 Now connect the wine conditioning unit to the power supply.

70

*INSTALLATION*

Installation

When the wine conditioning unit is connected to the power supply, the power connection symbol   will appear in the display after a short while.

Adjusting the lateral alignment of the appliance door

If the appliance door is not aligned with the housing side walls, the appliance door can be adjusted using the screws underneath the hinges.

 Touch the On/Off sensor.

The power connection symbol   will go out and the wine conditioning unit will start to cool.

The Push2open system on the wine conditioning unit is now activated (see

“Guide to the appliance – Door opening aid”).

 Loosen screws    and align the appliance door.

 Tighten screws   again.

71

*INSTALLATION*

Installation

 Secure the covers.

 Fit unit base   .

The cut-out in the plinth facing must be in the center of the wine conditioning unit.

 Insert foam block   supplied into the appliance plinth.

If the foam block is not fitted, the wine conditioning unit will not achieve optimum cooling and may be damaged.

 Fit ventilation grille   into the plinth facing. This will cause the foam block to be pushed back.

The foam block must be resting against the ventilation grille to ensure that the airflow is separated.

72

advertisement

Key Features

  • Built-in Compressor wine cooler 34 bottle(s) Number of temperature zones: 2 Black
  • Number of shelves: 4 Number of doors: 1
  • 35 dB
  • 146 kWh
  • Interior light Temperature alarm

Related manuals

advertisement

Table of contents