Electrical connection. Miele KWT 6322 UG, 10028620

Add to My manuals
80 Pages

advertisement

Electrical connection. Miele KWT 6322 UG, 10028620 | Manualzz

*INSTALLATION*

Installation

Electrical connection

Connect this appliance to a 110 – 120

VAC, 60 Hz and 15 amp (20 amp for side-by-side) circuit with a circuit breaker or fuse.

This appliance is equipped with a threeprong grounding plug to prevent shock hazards. It should be plugged directly into a properly grounded outlet. Do not cut or remove the grounding prong from the plug. If the plug does not fit the outlet, have the proper outlet installed by a licensed electrician. Do not use extension cords or ungrounded (two prong) adapters.

The outlet must be easily accessible so that the appliance can be quickly disconnected from the electrical supply in case of an emergency.

Failure to follow these instructions can result in death, fire, or electrical shock.

Improper connection of the equipment grounding conductor may result in electric shock. If you are in any doubt as to whether the appliance has been properly grounded, have the appliance checked by a qualified electrician or service technician.

Installation, repairs and other work by unqualified persons could be dangerous. The manufacturer will not be held responsible for damage or injury arising from unauthorized work.

Before installing the appliance, verify that the voltage, load and circuit rating information found on the data plate match the household electrical supply.

To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system. It is imperative that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician.

The plug and power cord must not come into contact with the back of the appliance as vibrations can cause damage to these components. This, in turn, could result in a short circuit.

Do not plug in other appliances behind this wine conditioning unit.

Do not use an extension cord to connect the appliance to the power supply.

Extension cords do not guarantee the required safety of the appliance (danger of overheating, for example).

Do not connect the appliance to an inverter such as those used with an autonomous energy source e.g. solar power . When switched on, peak loads in the system can cause the safety switch-off mechanism to be triggered.

This can damage the electronic unit.

The appliance must not be used with so-called energy-saving devices either. These reduce the amount of energy supplied to the appliance, causing it to overheat.

If the power cord needs to be replaced, this must be done by a qualified technician.

73

Information for dealers

Demo mode  

The appliance can be demonstrated in the showroom or at exhibitions in

“Demo mode”. In this mode the control panel and interior lighting are active but the compressor remains turned off, so that the appliance does not cool down.

Turning on Demo mode

 Switch the wine conditioning unit off by touching the On/Off sensor.

The temperature shown in the display will go out and the power connection symbol   appears.

 Keep your finger on the    sensor until the    symbol appears in the display.

 Then release the    sensor.

Demo mode is turned on and the    symbol is illuminated in the display.

Turning off Demo mode

The    symbol is illuminated in the display.

 Touch and hold the    sensor.

 Touch the settings sensor.

All symbols available for selection will appear in the display and the    symbol flashes.

 At the same time, briefly touch the

On/Off sensor (without letting go of the    sensor).

 Touch the sensors for setting the temperature (    or    ) repeatedly until the    symbol flashes in the display.

 Touch the OK sensor to confirm your selection.

The  1   symbol flashes in the display

(meaning: Demo mode is active) and the    symbol is illuminated.

74

 Touch the    or    sensor so that the symbol  0  appears in the display

(meaning: Demo mode is inactive).

 Touch the OK sensor to confirm your selection.

The selected setting will be adopted and the    symbol will flash.

 Touch the settings sensor to leave the settings mode.

Otherwise the appliance will exit the settings mode automatically after approximately one minute.

Demo mode is turned off and the    symbol disappears.

Information for dealers

75

Please have the model and serial number of your appliance available when contacting Customer Service.

U.S.A.

Miele, Inc.

National Headquarters

9 Independence Way

Princeton, NJ 08540

Phone:

Fax:

800-843-7231

609-419-4298 www.mieleusa.com

Customer Service & Support

Phone: 888-99-MIELE(64353)

Fax: 888-586-8056 [email protected]

International Headquarters

Miele & Cie. KG

Carl-Miele-Straße 29

33332 Gütersloh

Germany

Canada

Importer

Miele Limited

Headquarters and Miele Centre

161 Four Valley Drive

Vaughan, ON L4K 4V8 www.miele.ca

Customer Care Centre

Phone: 800-565-6435

905-532-2272 [email protected]

KWT 6322 UG, KWT 6322 UG ed/cs en-US M.-Nr. 10 531 321 / 00

advertisement

Key Features

  • Built-in Compressor wine cooler 34 bottle(s) Number of temperature zones: 2 Black
  • Number of shelves: 4 Number of doors: 1
  • 35 dB
  • 146 kWh
  • Interior light Temperature alarm

Related manuals

advertisement

Table of contents