3.15 Disassembly of the Switch from the Rack. Mellanox Technologies SwitchX

Rev 1.3

3.15

Disassembly of the Switch from the Rack

To disassemble the switch from the rack:

1. Unplug and remove all connectors.

2. Unplug all power cords.

3. Remove the ground wire.

4. Unscrew the 2 bolts from the side of the switch with the bracket.

Basic Operation and Installation

Support the weight of the switch when you remove the screws so that the switch does not fall.

5. Slide the switch from the rack.

6. Remove the rail slides from the rack.

7. Remove the ten caged nuts.

3.16

Disposal

According to the WEEE Directive 2002/96/EC, all waste electrical and electronic equipment (EEE) should be collected separately and not disposed of with regular household waste.

Dispose of this product and all of its parts in a responsible and environmentally friendly way.

Follow the instructions found in the Mellanox Web site at mellanox.com

for proper instructions to disassemble and dispose of the Switch according to the WEEE directive.

3.17

Resetting the Switch

On the connector side panel under the system LEDs is a reset button. This reset button requires a tool to be pressed.

DO NOT use a sharp pointed object such as needle or push pin for pressing the Reset button. Sharp objects can cause damage, use a flat object to push the reset button.

42 Mellanox Technologies

SwitchX 36-Port QSFP 40Gb/s Ethernet System Hardware User Manual

Figure 33: Reset Button

Press the reset button to reset the main and management CPUs and to delete the existing password.

Rev 1.3

This button resets both the CPU of the switch device and the CPU of the management module. It thereby resets all of the ports by bringing them down and powering them up when the button is pushed. A quick push of this button performs this reset. When the button is held down for 15 seconds the switch is reset and the password is deleted. You will then be able to enter without a password and make a new password for the user “admin” .

Mellanox Technologies 43