Text Setup. Samsung svr-945, svr-1680c, SVR-1645, svr-480, SVR-PC, SVR-3200, SVR-1660C, SVR-960C

Add to my manuals
122 Pages

advertisement

Text Setup. Samsung svr-945, svr-1680c, SVR-1645, svr-480, SVR-PC, SVR-3200, SVR-1660C, SVR-960C | Manualzz

User Manual

detection areas turn gray.

To select motion detection areas, use the navigation buttons to select them and press the [Enter] button or click them. Press the [ESC] button or right-click to return to the previous menu.

Sensor

A total of 16 sensors (9 sensors for the SVR-960C/945, 4 sensors for the SVR-480) can be set.

If All is selected, all channels are set to N.O or N.C. You can select channels and set them individually to N.O., N.C. or Off.

6.7.1 Text Setup

Recording

You can turn recording for text input on or off.

Sync Text With

This selects channels to link with text data.

Seek Header

This parameter is not needed if, just like Star Finger-007, protocols are already registered and supported for various types of data that comes from external devices (Access Control, POS,

ATM, etc.). However, this parameter is needed to see how one unit of data out of continuously incoming text data is structured. In other words, all data has its start and end points, and the header is data that is always inserted to indicate the start point. Therefore, by defining a header here, the DVR can recognize from the header that it is the start point of the data. Two headers can be set and detected because one device can send various types of data to external receivers.

Delimiter

The delimiter value may differ depending on the device used. For more information on delimiters, refer to the user manual or the device manufacturer.

Timeout (ms)

Lines defined below are the maximum number of text lines available for one piece of data. Even though data is standardized, lengths may differ. For example, three lines are programmed for client name input for an ATM, but if someone registers only his/her first name and last name, only two lines are provided when the person uses an ATM. However, the DVR cannot detect this automatically, so Timeout is used to determine how long is needed to recognize the received data as complete data after the last line is entered.

71

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents