ii DSP750 In-wall Digital Active Loudspeaker
User Guide
Important safety instructions
•
Read the instructions.
•
Keep these instructions.
•
Follow all instructions.
•
Do not use this apparatus near water.
•
Clean only with a dry cloth.
•
Install only in accordance with the manufacturer’s instructions.
•
Refer all servicing to approved service personnel.
Safety warnings
WARNING!
RISK OF ELECTRIC SHOCK – DO NOT OPEN
ATTENTION!
NE PAS OUVRIR – RISQUE DE DÉCHARGE ÉLECTRIQUE
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN
OR MOISTURE.
This apparatus has been designed with Class 1 construction and must be connected to a mains socket outlet with a protective earthing connection (the third grounding pin).
This apparatus uses a single-pole power switch. As a result it is not isolated from AC mains power when switched off at the front panel. The apparatus may be isolated from mains power either by unplugging the power connector from the rear of the unit, or by unplugging the connector at the opposing end of the power cord or cable from its supply outlet. As a result, either or both of these connectors should remain accessible.
Caution:
to reduce the risk of electric shock, do not remove cover. No user serviceable parts inside. Refer servicing to qualified service personnel.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
DSP750 In-wall Digital Active Loudspeaker
User Guide
iii
Climate
The equipment has been designed for use in moderate climates and in domestic situations.
Only use at an altitude not exceeding 2000m.
Radio interference
FCC Warning:
This equipment generates and can radiate radio frequency energy and if not installed and used correctly in accordance with our instructions may cause interference to radio communications or radio and television reception.
It has been type-tested and complies with the limits set out in
Subpart J, Part 15 of FCC rules for a Class B computing device.
These limits are intended to provide reasonable protection against such interference in home installations.
Safety warnings
•
Do not expose the unit to dripping or splashing.
•
Do not place any object filled with liquid, such as a vase, on the unit.
•
Do not place naked flame sources, such as lighted candles, on the unit.
EEC: This product has been designed and type-tested to comply with the limits set out in EN55032:2015 and
EN55024:2010 + A1:2015.
IP20 EQUIPMENT
To avoid overheating
•
Do not position the product in direct sunlight.
•
Do not position the product near heat sources, such as a radiator.
•
Leave at least 10cm around the product to ensure sufficient ventilation.
