j

180

STORAGE

Before Storage

When the motorcycle is to be stored for any length of time, it should be prepared for storage as follows.

•

Clean the entire vehicle thoroughly.

•

Run the engine for about five minutes to warm the oil, then stop it and drain the engine oil.

WARNING

Engine oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling.

•

Install the oil drain bolts and fill in fresh engine oil.

•

Empty the fuel tank (Fuel will deteriorate if left for a long time).

STORAGE

WARNING

Gasoline is extremely flammable and can be explosive under certain conditions, creating the potential for serious burns. Always stop the engine and never smoke while handling fuel. Make sure the area is well-ventilated and free from any source of flame or sparks; this includes any appliance with a pilot light.

Make sure the engine is cold before working.

Wipe any fuel off the engine before starting it. Gasoline is a toxic substance. Dispose of gasoline properly. Contact your local authorities for approved disposal methods.

•

Remove the spark plug and spray fogging oil directly into the cylinder. Kick the engine over slowly a few times to coat the cylinder wall. Install the spark plug.

•

Lubricate the drive chain and all the cables.

•

Spray oil on all unpainted metal surfaces to prevent rusting. Avoid getting oil on rubber parts and on the brakes.

•

Lift the motorcycle on a box or stand so that both wheels are raised off the ground (If this cannot be done, put boards under the front and rear wheels to keep dampness away from the tire rubber).

•

Tie a plastic bag over the muffler to prevent moisture from entering.

•

Cover the motorcycle to keep dust and dirt away from it.

After Storage

•

Remove the plastic bag from the muffler.

•

Make sure the spark plug is tight.

NOTE

○

Fit the plug cap securely onto the spark plug, and pull the cap lightly to make sure that it is properly installed.

STORAGE

181

•

Fill the fuel tank with fuel.

•

Check all the points listed in the Daily Pre-Ride

Checks section.

•

Perform a lubrication procedure in the Lubrication section.

j