Exhaust Fan. LB White L.B. White Therma Grow Greenhouse Heaters HW120

Exhaust Fan

The exhaust fan must be located at an upper area of the end wall opposite from the heater, preferably in an area higher than the heater’s discharge. See Fig. 5. The fan does not need to be directly in line to the heater. Ensure the exhaust fan is kept free of blockage.

FIG. 5

EXHAUST FAN IN UPPER

AREA OF GREEN HOUSE

CHAIN OR CABLE

ENTRY / EXIT

AIR INLET

10

HANGING THE HEATER

This heater may be mounted within the greenhouse for indoor heating applications. The heater may be installed on an optional indoor mounting bracket kit, part number 23651, which is installed on freestanding supports or mounted directly to the structure’s wall. Separate installation instructions accompany the kit.

The heater may also be suspended by chain to the greenhouse’s overhead structure by using an optional chain hanging kit, part number 07802. Refer to the following instructions.and illustrations.

1.

Assemble eyebolts and chain according to the illustration and tighten all eyebolts securely.

FIG. 6

2.

Ensure the heater is securely fastened to overhead supports and is hanging level. (Check crosswise and lengthwise.)

3.

See Fig. 5 for typical indoor installation. In any installation, consideration must be given to making sure the heater is located away from the people entering or exiting the greenhouse so they cannot accidentally knock the heater or tamper with the heater and its gas supply line. Additionally, the heater must be located so that it does not block the normal entryway or exit of the building. Observe and obey minimum clearance distances to combustible materials as stated in the specification section of this owner’s manual and on the heater’s dataplate.

EYEBOLT

NUT

FLAT WASHER

CHAIN

CAGE NUT CASE TOP