advertisement
GB regulations, consulting a specialist technician.
The Manufacturer declines all responsibility if the above safety precautions are not observed.
This appliance complies with the following E.E.C.
Directives:
87/308 EEC of 2/6/87 relative to radio interference suppression.
73/23 EEC of 19.2.73 (Low Voltage
Directive) and subsequent modifications.
89/336 EEC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent modifications.
Attention!
It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.
Building-in
Dimensions of the recess
Height of housing (1)
880
Depth of housing (2)
550
Width of housing (3)
560
1225 mm
550 mm
560 mm
It is necessary that the niche is provided with a conduct of ventilation having the following dimensions:
Depth 50 mm
Width 540 mm
For appropriate venting, follow indications in the figure.
67
GB
1. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2).
3. Press in the joint covers between the appliance and the kitchen furniture.
2. Open the door and push the appliance against the side of kitchen furniture opposite to that of the appliance hinges. Fasten the appliance with 4 screws (I) provided in the kit included with the appliance.
4. From the plastic cover (E), which is used to cover the hinge with the pivot pin, you must take away the part as indicated in the drawing.
This operation is made easer since there is, in the internal part of the cover hinge lid a groove that facilates the removal of this coomponent.
68
GB
"Remove the part marked with DX, if the pivot pin is inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into hinge holes. Snap hinge covers (E) into position.
5. Separate parts Ha, Hb, Hc, Hd as shown in the figure.
7. Fix cover (Hc) on guide (Ha) until it clips into place.
6. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied.
8. Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
69
GB
9. Remove the squares and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K).
11. Fix cover (Hd) on the small square
(Hb) until it clips into place.
10. Place the small square on the guide again and fix it with the screws supplied.
Should the alignment of the furniture door be necessary, use the clearance of slots.
At the end of this procedure, it is necessary to check if the door of the furniture closes properly.
70
GB
71
BORETTI B.V.
De Dollard 17
1454 AT Watergang
T + 31(0)20-4363439
F + 31(0)20-4361326
S 0900-2352673 (service)
The Netherlands
N.V. BORETTI S.A.
Ruperlweg 16
2850 Boom
T + 32(0)3-4508180
F + 32(0)3-4586847
Belgium
advertisement