DIGITAL TURNTABLES SCREEN. Monster Go-DJ


Add to my manuals
75 Pages

advertisement

DIGITAL TURNTABLES SCREEN. Monster Go-DJ | Manualzz

DIGITAL TURNTABLES SCREEN how to Control Tracks

In the Digital Turntable screen, you can control the playback position, tempo

(BPM) and other functions on a loaded track file.

Hot-Cue Points

Arc Selector

The Arc Selector is located at the side of the digital turntable. On Track-A, the

Arc Selector is located just to the left of the Digital Turntable platter. On Track-B, the Arc Selector is located just to the right of the Digital Turntable platter. The

Arc Selector is controlled by rotating and pressing the FUNCTION knob for various functions.

How to Use the Function Knob in the Arc Selector

The FUNCTION knob can be used for the Arc Selector by following these directions:

• Rotate the FUNCTION knob to move the highlight bar in the Arc Selector.

• Press the FUNCTION knob to execute a selected (highlighted) command in the Arc Selector.

A hot-cue point is assigned when the selection bar in the Arc Selector highlights either CUE 1, CUE 2, CUE 3 or CUE 4 and then the FUNCTION knob is pressed down.

Hot-cue points can be assigned by following these directions:

• Locate the area of the track where you want to assign a hot-cue point by rotating the Digital Turntable and/or tapping on the progress bar.

• Use the FUNCTION knob to select which hot-cue point that you want to assign the location to (CUE 1, CUE 2, CUE 3, CUE 4).

• Press the FUNCTION knob to assign and record the hot-cue point.

Please note: If you select a hot-cue point that is listed in white by pressing the FUNCTION knob during playback, the corresponding playback position is recorded as a hot-cue point. In the case of a hot-cue point labeled with colored text (other than white), pressing the FUNCTION knob enables you to jump to the recorded hot-cue point.

34

DIGITAL TURNTABLES SCREEN

Recorded hot-cue points are preserved even after the unloading of the track file, a shutdown of the Monster ® GO-DJ ™ and/or the reset of the settings.

Recorded hot-cue points can be cleared with the CUE CLEAR command by following these directions:

• Use the FUNCTION knob to select the CUE CLEAR command on the

Arc Selector.

• Press the FUNCTION knob to activate the CUE CLEAR command.

You will notice that the recorded hot-cue points (recognizable by the colored text) will begin flashing.

• Use the FUNCTION knob to select which hot-cue point will be cleared.

• Press the FUNCTION knob to clear the recorded position of the hot-cue point.

Loop

Any portion of the track can be looped by using the loop function in the

Arc Selector by following these directions:

• Use the FUNCTION knob to select the specific loop range that you want to activate.

• Press the FUNCTION knob to activate the loop function. Depending on what is selected on the Options screen, the loop function will stop when the FUNCTION knob is pressed again, released or rotated.

• Select the “Loop Range” command on the Arc Selector to change the loop range, which ranges from ¹∕₈ beats to 32 beats.

Please note: During a loop function, the Digital Turntable will activate the

LOOP ADJUST mode, which is signified by the left and right arrows located in the center of the Digital Turntable. Use the Loop Adjust function to change the position of loop range. You can select various options on how to change the loop range in the Options screen.

35

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement

Table of contents