Loading and Assigning Samples. Monster Go-DJ


Add to my manuals
75 Pages

advertisement

Loading and Assigning Samples. Monster Go-DJ | Manualzz

SAMPLERS SCREEN

Loading and Assigning Samples

Assigning Samples to Specific Pads

00

04

01

05

02

06

03

07

Dedicated folders to store sample files for the sampler pads are created automatically in the GO-DJ Drive. These directories are as follows:

• GO-DJ DRIVE

• Pad

• [oneshot, loop, drone]

By storing WAV files in these directories, you can assign them to the corresponding sampler pads. Just like the file format for playback files, .WAV files need to be in the format of 8-48 kHz and 8-24 bit. If your files are available but not in 44.1 kHz, 16 bit stereo, the files are converted during the reboot cycle. Once converted properly, the sample files are able to be assigned.

Please note: You cannot use .mp3 files for samplers.

You can specify a pattern and position and assign a sample to each in the following steps:

• Connect the Monster ® GO-DJ ™ to a computer.

• Upload the sample to the corresponding sub-folder located in the

“/GO-DJ Drive/pad” folder. The audio sample file needs to be in .WAV format. The file name should be name “padXX.wav” where XX corresponds to the sampler pad position number. The “XX” in the filename template is a number between 00 to 07 as the image below shows. For example, if you want to assign a specific sample to the sampler pad labeled 03 in the diagram, name the file as “pad03.wav” for proper assignment.

• Disconnect the Monster ® GO-DJ ™ from the computer properly (set

USB Mode to the OFF position in the Options screen), and reboot the

Monster ® GO-DJ ™ .

48

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement

Table of contents