Assigning Samples to the Beat Sequencer. Monster Go-DJ


Add to my manuals
75 Pages

advertisement

Assigning Samples to the Beat Sequencer. Monster Go-DJ | Manualzz

SAMPLERS SCREEN

Assigning Samples to the Beat Sequencer

Dedicated folders that store sample files for the Beat Sequencer are automatically created in the GO-DJ Drive (/GO-DJ DRIVE/seq/[a-d]). By storing .WAV files here, you can assign them to the Beat Sequencer. Just like the files used for playback, .WAV files need to be in 8-48 kHz and 8-24 bit format. If your files are available but not in 44.1 kHz, 16 bit, stereo, then the files are converted during the reboot cycle. After the reboot, the properly converted files are then able to be assigned.

Please note: You cannot use .mp3 files for the Synthesizer Keyboard.

Assigning Samples to Specific Positions

(YY)

00

01

02

03

04

05

You can assign samples to the Beat Sequencer with the following steps:

• Connect the Monster ® GO-DJ ™ to a computer.

• Navigate to the corresponding folder (choose one of the folders in

“/GO-DJ DRIVE/seq/”).

• Upload .WAV format files named “seqYY.wav” in the corresponding folder.

The “YY” in the file name template is a number between 00 to 05. For example, a user-loaded file named “seq03.wav” that is stored in the “b” folder is allocated to the fourth (4th) part (or column) of Pattern B.

• Disconnect the Monster ® GO-DJ ™ from the computer properly (set

USB Mode to the OFF position in the Options screen), and reboot the

Monster ® GO-DJ ™ .

54

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement

Table of contents