Use of Expression Pedal/Foot Switch. Zoom Tri Metal TM-01, G2.1NU, G21U, G2.1u

Using the Built-in Expression Pedal

Using the Built-in Expression Pedal

The expression pedal on the top panel of the G2.1u lets you adjust the effect sound or the volume in real time during play. Which element is controlled by the pedal can be selected for each patch individually.

Select the patch for which the expression pedal is to be used

Select the element to be controlled by the expression pedal

Press the [PEDAL ASSIGN] key to select the element to be controlled by the expression pedal. The row of LEDs above the key shows which element is currently selected.

Operate the pedal

While playing your instrument, move the expression pedal up or down.

Move up or down

To switch a module on or off

When you push the expression pedal fully down, the module selected with the [PEDAL ASSIGN] key is switched on or off.

Push fully down

18

The respective selection is indicated as follows.

• All LEDs are out

The expression pedal has no effect.

• VOLUME

The expression pedal controls the volume for the entire patch.

• WAH/EFX, DRIVE, MOD/SFX, DELAY, REVERB

The expression pedal controls a parameter from the respective module.

HINT

• Which parameter will be changed by the expression pedal depends on the effect type selected for the respective module. For details, see pages 27 - 33.

• The pattern in which the parameter changes when the expression pedal is operated can be selected in edit mode from four choices. For details, see page

34.

• If the module to which the expression pedal was assigned is set to OFF in the patch, the LED flashes. In this case, operating the expression pedal has no effect.

ZOOM G2.1u

ZOOM G2.1u

Store the patch as necessary

The expression pedal setting can be stored for each patch individually.

NOTE

If you select another patch in play mode without storing the patch, any changes that you have made to the settings will be lost.

19