MOUNTING AND SET-UP. Vents VK 16 Pages Pagine ページ
Vents VK centrifugal inline fan is designed for efficient supply or exhaust ventilation of various premises. It can be used to connect to air ducts of different diameters, ranging from 100 to 315 mm. The fan is equipped with a reliable asynchronous motor and features low noise operation. Some models come with additional options like a speed controller or a built-in timer. Vents VK fans are suitable for various applications, including ventilation of bathrooms, kitchens, offices, and other residential or commercial spaces.
advertisement annuncio pubblicitario 広告
Ask Al about MOUNTING AND SET-UP. Vents VK
Chatbot has read manual and is ready to answer your questions.
1
3
8
5
Two short pulses
One pulse
The motor shuts down
Alarm code
MOUNTING AND SET-UP
Temperature sensor failure
Alarm description
Short circuit of the temperature sensor
Breakdown of the temperature sensor
READ THE USER'S MANUAL BEFORE INSTALLING THE UNIT.
The fan is suitable both for horizontal or vertical mounting on the floor, on the wall or on the ceiling. Air motion in the system must be in compliance with the direction of the arrow on the fan casing. Install a hood on the intake spigot side in case of vertical fan installation. When installing the fan horizontally, provide a straight air duct section at least 1 m long on the intake spigot side.
1 m
9
VK
Mounting sequence:
1. Remove the bolts on both sides of the casing, install the mounting brackets and tighten the bolts, aligning the holes in the brackets with the holes in the casing.
2. Mark holes for drilling.
3. Drill the holes in the wall or the ceiling for dowels.
4. Fix the fan with the screws.
5. Connect the air ducts of the corresponding diameter to the fan.
2
4 www.ventilation-system.com
advertisement
Related manuals
advertisement
Table of contents
- 2 CONTENTS
- 3 Safety requirements
- 5 PURPOSE
- 5 DELIVERY SET
- 5 DESIGNATION KEY
- 6 TECHNICAL DATA
- 7 DESIGN AND OPERATING PRINCIPLE
- 8 MOUNTING AND SET-UP
- 9 CONNECTION TO POWER MAINS
- 10 TECHNICAL MAINTENANCE
- 10 Storage and transportation regulations
- 11 Manufacturer’s warranty
- 12 Certificate of acceptance
- 12 Seller information
- 12 Installation certificate
- 12 Warranty card