Location. Cozy Hi-Efficient Direct Vent

LOCATION OPTIONAL KITS

1. The wall furnace must be installed on an outside wall, unless optional Kit No. HEVK-5 is used.

2. For most efficient performance, locate furnace as centrally as possible in the area to be heated and where occupants may move about freely without coming into contact with the cabinet, and within reach of a 115V wall outlet.

3. If the furnace is installed in a basement, a 12” clearance must be maintained between ground level and the bottom of the vent cap. Do not install furnace where vent cap will terminate in a window well or any other opening below ground level. (See Figure 3). Do not allow snow accumulation to build up within 12” of the vent cap.

1. HEVK-5 - To extend vent 5 foot from heater. This will allow vent cap to be installed above grade from basement or to an outside wall.

A total of 3 kits with 2 additional elbows may be used.

For additional kit installation instructions, see page 15.

FIG. 3

12” MINIMUM

ABOVE GRADE

WITHOUT

EXCAVATION

Page 7 1017952-A