• WFF81-C Fan Kit. Cozy Gravity Wall Furnace with PilotPro, Gravity Wall Furnace

MODEL WFF81-C OPTIONAL FAN KIT - (Optional)

Installation Instructions

NOTE: This fan kit is to be installed after installation of the wall furnace and with the wall furnace front panel in place.

STEP 1.

This appliance, when installed, must be electrically grounded in accordance with local codes, or in the absence of local codes, with the latest edition of the National Electric Code, ANSI/NFPA No. 70.

In Canada, see the current Canadian Electrical

Code CSA C22.1.

STEP 2.

Set fan kit on top of the wall furnace front panel.

Using the back top edge of the fan kit cabinet as a guide, mark a horizontal line across the wall.

Mark a small vertical line which aligns with the slot located toward the rear of the fan kit casing.

STEP 3.

Using the four one inch screws provided, secure the wall mounting bracket to wall 1/8” below the horizontal line. Fan attachment bracket must be up and threaded nut sert aligned with the small vertical line.

Note: Anchors (not provided) may be required.

STEP 4.

Remove junction box and connect 115v power supply in accordance with the wiring diagram.

Replace junction box.

STEP 5.

Set fan kit on top of wall furnace front panel. Slot should align with the nut sert. Secure fan kit to wall mounting bracket with thumb screw provided.

FIG. 13

JUNCTION

BOX

THREADED

NUT SERT

FAN

ATTACHMENT

BRACKET

WALL

MOUNTING

BRACKET

ONE INCH

SCREW (x4)

FAN KIT

WALL FURNACE

FRONT PANEL

WFF81 - C WIRING SCHEMATIC

WIRING

DIAGRAM

THUMB

SCREW

FIG. 14

GROUND

L1 BLACK

115 VAC

L2 WHITE

115 VAC

WHITE

BLACK

BLACK

SLOT

L2

WHITE

WHITE

MOTOR

BLACK BLACK

GREEN GROUND WIRE

FAN SWITCH

BLACK

L1

BLACK

115 VAC 60 HZ - LESS THAN 12 AMPS. IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THIS APPLIANCE MUST BE

REPLACED, IT MUST BE REPLACED WITH TYPE THERMOPLASTIC 105 DEGREE C WIRE OR ITS EQUIVALENT.

Page 28 1018454-E