GEARSHIFT PEDAL. Honda CBR125R

The Honda CBR125R is a lightweight and powerful motorcycle designed for both beginners and experienced riders. It features a liquid-cooled, single-cylinder engine with PGM-FI fuel injection, delivering reliable performance. The CBR125R also boasts a modern design with sleek bodywork and a comfortable riding position. This manual provides comprehensive service procedures, maintenance schedules, and troubleshooting information for the CBR125R, ensuring optimal performance and safety.

CLUTCH/GEARSHIFT LINKAGE

GEARSHIFT PEDAL

REMOVAL

Remove the lower cowl (page 2-8).

When removing the gearshift pedal, mark the pedal position to ensure correct reassembly in its original location.

Remove the pinch bolt and gearshift arm.

Remove the left step holder mounting bolts and left step holder assembly.

PINCH BOLT BOLTS

STEP HOLDER ASSEMBLY

DISASSEMBLY/ASSEMBLY

Remove the snap ring and gearshift pedal.

GEARSHIFT PEDAL

Remove the cotter pins and washers then remove the gearshift tie rod from the gearshift pedal and gearshift arm.

Apply grease to the gearshift tie rod sliding area and install the gearshift pedal and gearshift arm.

Install the washers and new cotter pins.

TIE ROD

GEARSHIFT ARM

SNAP RING

COTTER PINS/WASHERS

Apply grease to the gearshift pedal pivot sliding area.

Install the gearshift pedal to the left step holder.

GEARSHIFT PEDAL

PEDAL

10-18

CLUTCH/GEARSHIFT LINKAGE

Make sure the snap ring is firmly seated in the groove.

Install the snap ring.

INSTALLATION

Install the left step holder assembly and left step holder mounting bolts, tighten the bolts to the specified torque.

TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)

Install the gearshift arm on its original position as marked during removal.

Install and tighten the pinch bolt securely.

PINCH BOLT BOLTS

SNAP RING

STEP HOLDER ASSEMBLY

Standard pedal height is 53 mm (2.1 in) below the top of the left step as shown.

53 mm (2.1 in)

GEARSHIFT PEDAL

10-19

Key Features

Liquid-cooled engine
PGM-FI fuel injection
Sleek design
Lightweight
Powerful
Comfortable riding position
Comprehensive service manual

Frequently Answers and Questions

What type of engine oil is recommended for the CBR125R?

Honda recommends using "4-stroke motorcycle oil" or an equivalent with API classification SG or higher and JASO T 903 standard: MA. The viscosity should be SAE 10W-30.