Factors Affecting Performance. Frigidaire FGID2476SF, 988307, 998042, GRSS2652AFxx, 998015, 1588035, 1010204, FGID2476SF , 988250, 957555

Add to My manuals
20 Pages

advertisement

Factors Affecting Performance. Frigidaire FGID2476SF, 988307, 998042, GRSS2652AFxx, 998015, 1588035, 1010204,  FGID2476SF , 988250, 957555 | Manualzz

FACTORS AFFECTING PERFORMANCE

Rinse Aid

Rinse aid greatly improves drying, reduces water spots, filming. With it water “sheets” off dishes rather than forming water droplets that cling and leave spots.

A dispenser, located next to the detergent cup, automatically releases a measured amount of rinse aid during the last rinse.

If spotting and poor drying are problems, increase the amount of rinse aid dispensed.

The indicator will be dark when full and will show clear when it is time to refill.

To add liquid rinse aid:

1. Lift up the rinse aid cover to open.

2. Fill the rinse aid dispenser with liquid rinse aid until the liquid reaches the indicated fill level.

DO NOT overfill.

3. Press the rinse aid cover down firmly to close.

4. Wipe up any spills with a damp cloth.

How to adjust the rinse aid dosage

Press and hold the RINSE ONLY and DELAY START pad for 5 seconds until the status window shows rinse aid level.

Pressing the DELAY START pad increases the increment level (L0-L6).

Once the rinse-aid level reaches L6, the status window will start back at level L0.

Pressing the START button or just pausing for a few seconds confirms the rinse aid level setting: the status window shows the duration of the cycle.

Water Pressure

The hot water line to dishwasher must provide water pressure between 20 and 120 psi.

Low water pressure may occur when laundry or showers are in operation.

If you experience poor wash performance you may need to wait until water use is reduced before starting the dishwasher.

Indicator

Rinse Aid

Compartment

Rinse Aid

Cover

The dispenser holds enough for 11 to 66 washes, depending on setting.

Water Temperature

Hot water is needed for best dishwashing and drying results.

Water entering dishwasher should be at least 120°F (49°C) to give satisfactory results.

To check water temperature entering dishwasher:

• Turn on hot water faucet nearest dishwasher for several minutes to clear cool water from pipes.

• Hold a candy or meat thermometer in the water stream to check the temperature.

• If temperature is below 120°F (49°C), have a qualified person raise the hot water heater thermostat setting.

IMPORTANT

Before starting a cycle, run hot water to clear cool water from pipe.

NOTA

The HEAT DRY option in combination with rinse aid will enhance drying performance. The energy required to use the HEAT DRY option costs pennies per cycle. You may choose not to select the HEAT DRY option; however you will have items in your dish load that will not be completely dry at the end of the cycle.

15

advertisement

Related manuals