2. REGISTERING HOME. Toyota Sequoia

1. REAR VIEW MONITOR SYSTEM

DISTANCE GUIDE LINES

Visually check the surroundings and the area behind the vehicle. On the screen, it appears that a truck is parking at point B. However, in reality if you back up to point A, you will hit the truck.

On the screen, it appears that A is closest and C is furthest away. However, in reality, the distance to A and C is the same, and B is farther than A and C.

Positions of A, B and C

C

A B

C

B

A

290

1. REAR VIEW MONITOR SYSTEM

3. THINGS YOU SHOULD KNOW

IF YOU THINK SOMETHING IS WRONG

If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check.

If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer.

Symptom

The image is difficult to see

The image is blurry

Likely cause

 The vehicle is in a dark area

 The temperature around the lens is either high or low

 The outside temperature is low

 There are water droplets on the camera

 It is raining or humid

 Foreign matter (mud etc.) is adhering to the camera

 Sunlight or headlights are shining directly into the camera

 The vehicle is under fluorescent lights, sodium lights, mercury lights etc.

Dirt or foreign matter (such as water droplets, snow, mud etc.) is adhering to the camera.

The image is out of alignment The camera or surrounding area has received a strong impact.

The fixed guide lines are very far out of alignment

The camera position is out of alignment.

Solution

Back up while visually checking the vehicle’s surroundings. (Use the monitor again once conditions have been improved.)

The procedure for adjusting the picture quality of the rear view monitor system is the same as the procedure for adjusting the navigation

screen. (See page 30.)

Rinse the camera lens with water and wipe it clean with a soft cloth.

Wash with a mild soap if the dirt is stubborn.

Have the vehicle inspected by your Toyota dealer.

Have the vehicle inspected by your Toyota dealer.

9

291