Connecting the Printer to Your Computer. Epson LQ-510

Connecting the Printer to Your Computer

If the self test printed correctly, you are now ready to connect the printer to your computer.

If your computer has a parallel interface and you have a suitable shielded cable, you should be able to connect your printer immediately. The steps below describe how to connect the parallel interface cable.

If your computer requires another type of interface, you need to install an optional interface board. See the Interface Boards section in Chapter 5.

If you are not sure which type of interface cable is required, see your computer manual.

The Parallel Interface

Connect the parallel interface cable as described below:

1. Make sure that both your printer and computer are turned off.

1-22

Setting

Up the Printer

Connecting the Printer to Your Computer

2. Plug the cable connector securely into the printer.

3. Squeeze the wire clips together until they lock in place on either side of the connector.

Setting Up the Printer 1-23

Connecting the Printer to Your Computer

If your cable has a ground wire, connect it to the ground screw beneath the interface connector.

Plug the other end of the cable into the computer. If there is a ground wire at the computer end of the cable, attach it to the ground connector at the back of the computer.

1-24 Setting Up the Printer