SECTION 3. MACHINE CONTROLS AND INDICATORS. JLG AM Series, 38AM
Advertisement
Advertisement
SECTION 3 - MACHINE CONTROLS AND INDICATORS
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL 3.2 CONTROLS AND INDICATORS
NOTICE
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE APPLICA -
TION AND OPERATION. THE USER AND OPERATOR ARE RESPONSIBLE FOR
CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to understand control functions.
Ground Control Station
NOTE: For overnight parking or battery charging, be sure the
POWER ON/OFF KEY SWITCH is positioned to OFF to pre vent battery drain.
1.
POWER ON/OFF Key Switch
A key switch located on the ground control station controls power to all functions on the machine.
To order go to
Discount-Equipment.com
ground controls when RESET (ON). When pushed in (OFF), power is shut off to the platform and ground controls.
3.
RAISE/LOWER SWITCH
The two position switch allows the platform to be raised or lowered.
4.
HYDRAULIC RESERVOIR / CIRCUIT BREAKER / FUSE
(located inside the ground control station housing)
The hydraulic oil level can be checked through an access hole in the side of the cover.
31215807 3-1
SECTION 3 - MACHINE CONTROLS AND INDICATORS
NOTE: Check hydraulic oil only when platform is completely low ered and after cycling platform up/down a few times.
A 20 amp reset type circuit breaker is located on the cover of the electrical box on AM-AC Models.
On AM-DC Models, a 5 Amp fuse is located inside the ground control station cover.
3
2
1
3-2
To order go to
Discount-Equipment.com
Figure 3-1. Ground Control Station.
1.
Power ON/OFF Key
2.
Power/Emergency Stop
3.
Raise/Lower Switch
4.
Hydraulic Reservoir/Circuit Breaker/Fuse
31215807
SECTION 3 - MACHINE CONTROLS AND INDICATORS
Manual Descent Valve
Located at the rear and bottom of the base frame. This pull to release - spring loaded return valve (RED Knob), allows for lowering of the platform in an emergency or power failure.
Platform Control Station
1.
POWER/EMERGENCY STOP
A two position mushroomed shaped switch furnishes power to the platform and ground controls when RESET (ON).
When pushed in (OFF), power is shut off to the platform and ground controls.
2.
PLATFORM UP Button.
When depressed simultaneously with ENABLE button raises the platform.
2
Discount-Equipment.com
3
3.
FUNCTION ENABLE Button.
This (GREEN) button must be depressed for machine to operate.
order
4.
To
When depressed simultaneously with ENABLE button lowers the platform.
Figure 3-2. Manual Descent Valve Location.
1.
Manual Descent Valve
2.
Tie-Down Lugs
3.
Mast
31215807 3-3
SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-4
1
2
3
4
Figure 3-3. Platform Control Station.
1.
Emergency Stop (RED)
2.
Platform UP (WHITE)
3.
Function Enable (GREEN)
4.
Platform DOWN (WHITE)
To order go to
Discount-Equipment.com
31215807
SECTION 3 - MACHINE CONTROLS AND INDICATORS
3.3 DECAL INSTALLATIONS
30
27
29
23
25
28
24
26
4
20
13
10
31
32
15
22
14 go
1
3 to
12
21
To
12 order
21
16 2 19 16
Figure 3-4. Decal Installation. (ANSI/CSA)
8
OAR00420
31215807 3-5
Item
1
8
9
6
7
4
5
2
3
10
11
12
13 (3)
14
15
16
17
18
19
20
21
SECTION 3 - MACHINE CONTROLS AND INDICATORS
Table 3-1. Decal Installation Chart (ANSI and CSA) (See Figure 3-4.)
ANSI
1001131273
ANSI
(LAT)
ANSI
(BRZ)
ANSI
(JPN)
ANSI
(CHI - SIMP)
ANSI
(CHI - TRAD)
1703784
1703785
1703786
1703787
1703789
1704030
1704031
1704032
1704033
1704034
To
1702300
Bar Code - Not Available
Model Designation - 25AM-1703903 / 30AM-1703904 / 38AM-1001256057 order
1704022
1704023
1704024
1704025 go
Not Used
Not Used
Not Used
Serial Number Plate - Not Available to
Not Used
1704088
1704089
1704090
1704078
1704079
1704081
1706696
1706697
1704091
1701509
1704092
1703817
Not Used
Not Used
1001115864
1703681 - JLG Logo
1001126700 - Manlift
1704082
1704083
1706695
1706699
3-6
CSA
(FRE)
1001131273
1703784
1703785
1703786
1703787
1703789
31215807
31215807
SECTION 3 - MACHINE CONTROLS AND INDICATORS
Table 3-1. Decal Installation Chart (ANSI and CSA) (See Figure 3-4.)
Item
26
27
28
29
(1)
22
23
24
25
ANSI
1001223055
1001228370
1001231801
1703778
1703779
1703780
1703781
ANSI
(LAT)
1001224049
1704027
1704028
1704029
29 (2)
30
31
32
NOTE: (1) 30AM/38AM Only
(2) - 25AM Only go
ANSI
(BRZ)
1001224049
1704019
1704020
1704021
ANSI
(JPN)
1001224053
1704084
1704085
1704086
1001256055
1001256056
1001110242 - JLG Service
ANSI
(CHI - SIMP)
1001224051
1704075
1704076
1704077
ANSI
(CHI - TRAD)
1001224050
1706692
1706693
1706694
To order
CSA
(FRE)
1001223971
1001228370
1703778
1703780
1703781
3-7
SECTION 3 - MACHINE CONTROLS AND INDICATORS
4 3
24
25
10 OR
5
CE SPEC.
3
4
5
10
AUSTRALIAN
SPEC.
1
11
13
18
15
9
8
2
14 go
21
20
7
23 20
17 To
16
Figure 3-5. Decal Installation (CE and AUS)
12 19 16
OAR00440
3-8 31215807
31215807
SECTION 3 - MACHINE CONTROLS AND INDICATORS
1
2
3
12
13
14
15
16
17
8
9
10
11
4
5
6
7
Table 3-2. Decal Installation Chart (CE and AUS Specification) (See Figure 3-5.)
Item
CE
(ENG)
CE
(DUT)
CE
(FRE)
CE
(GER)
CE
(ITA)
CE
(SPA)
1701509
Not Used
1704094
(1)
/ 1704095
(2)
1705801
1702802
1705803
1705805
To order go to
1705831
Discount-Equipment.com
1001098579
Not Used
1702300
Not Available - BarCode
1702928
1703681
1703817
4410051
(AUS)
—
—
1703780
1703781
1703785
1703786
1703784
1703787
1703778
3-9
SECTION 3 - MACHINE CONTROLS AND INDICATORS
Table 3-2. Decal Installation Chart (CE and AUS Specification) (See Figure 3-5.)
Item
CE
(ENG)
CE
(DUT)
CE
(FRE)
CE
(GER)
CE
(ITA)
CE
(SPA)
18
19
20
Model Designation - 25AM-1703903 / 30AM-1703904 / 38AM-1001256057
1001115864
1001126700
21
22
23
24
25
Serial Number Plate - Not Available
Not Used
Not Used
120V - AC - 3255761 / 220V-240V AC - 3255760
1703994 (Optional)
NOTE: (1) - 30AM/38AM
(2) - 25AM to
Discount-Equipment.com
(AUS)
1703789
1705796
To order go
3-10 31215807
TO PURCHASE THIS PRODUCT PLEASE CONTACT US
Equipment Financing and
Extended Warranties Available
Discount-Equipment.com is your online resource for commercial and industrial quality parts and equipment sales.
561-964-4949 visit us on line @ www.discount-equipment.com
Select an option below to find your Equipment
We sell worldwide for the brands: Genie, Terex, JLG, MultiQuip, Mikasa, Essick, Whiteman,
Mayco, Toro Stone, Diamond Products, Generac Magnum, Airman, Haulotte, Barreto, Power
Blanket, Nifty Lift, Atlas Copco, Chicago Pneumatic, Allmand, Miller Curber, Skyjack, Lull,
Skytrak, Tsurumi, Husquvarna Target, Stow, Wacker, Sakai, Mi-T-M, Sullair, Basic, Dynapac,
MBW, Weber, Bartell, Bennar Newman, Haulotte, Ditch Runner, Menegotti, Morrison, Contec,
Buddy, Crown, Edco, Wyco, Bomag, Laymor, EZ Trench, Bil-Jax, F.S. Curtis, Gehl Pavers, Heli,
Honda, ICS/PowerGrit, IHI, Partner, Imer, Clipper, MMD, Koshin, Rice, CH&E, General Equipment ,Amida, Coleman, NAC, Gradall, Square Shooter, Kent, Stanley, Tamco, Toku, Hatz,
Kohler, Robin, Wisconsin, Northrock, Oztec, Toker TK, Rol-Air, APT, Wylie, Ingersoll Rand /
Doosan, Innovatech, Con X, Ammann, Mecalac, Makinex, Smith Surface Prep,Small Line,
Wanco, Yanmar

Public link updated
The public link to your chat has been updated.
Advertisement