2.1 Basic Configuration Instructions. Shuttle SN27P2, SN27P2 V2

Add to my manuals
62 Pages

advertisement

2.1 Basic Configuration Instructions. Shuttle SN27P2, SN27P2 V2 | Manualzz

2. SETTING UP YOUR RAID CONFIGURATION

2.1 Basic Configuration Instructions

The following are the basic steps for configuring NVRAID:

Non-Bootable RAID Array

1. Choose the hard disks that are to be RAID enabled in the system BIOS.

2. Specify the RAID level, either Mirroring (RAID 1), Striping (RAID

0), Striping and Mirroring (RAID 0+1), RAID 5, or Spanning

(JBOD) and create the desired RAID array.

3. Run the Windows nForce Setup application and install the

RAID software.

4. Initialize the NVRAID Array Disks

See “Initializing and Using the Disk Array” on page 29.

Bootable RAID Array

1. Choose the hard disks that are to be RAID enabled in the system BIOS.

2. Specify the RAID level, either Mirroring (RAID 1), Striping (RAID

0), Striping and Mirroring (RAID 0+1), RAID 5,or Spanning

(JBOD) and create the desired RAID array.

3. Boot from the Windows CD and install the nForce RAID software.

4. Initialize the NVRAID Array Disks

See “Initializing and Using the Disk Array” on page 29.

10

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals