2.3 Setting Up a Bootable NVRAID Array. Shuttle SN27P2, SN27P2 V2

Add to my manuals
62 Pages

advertisement

2.3 Setting Up a Bootable NVRAID Array. Shuttle SN27P2, SN27P2 V2 | Manualzz

2.3 Setting Up a Bootable NVRAID Array

This section explains how to configure a bootable NVIDIA RAID array.

Setting Up the BIOS

1. Start your computer, then press Delete to enter the BIOS setup.

The BIOS CMOS Setup Utility screen appears.

Figure 2.10 BIOS CMOS Setup Utility Main Screen

2. Use the arrow keys to select Integrated Peripherals

(see Figure 2.10), then press Enter .

3. Use the arrow keys to select Onboard IDE Device , then press Enter . The Integrated Peripherals window appears.

20

Figure 2.11 Integrated Peripherals Screen

4. Use the arrow keys to select the RAID Function Setup

(see Figure 2.11).

5. Press Enter.

The RAID Function Setup screen appears.

Figure 2.12 RAID Function Setup Screen

6. From the RAID Config window, globally enable RAID, then en able the SATA ports with disks that you want to use for RAID.

If RAID is enabled globally but not enabled on the individual SATA port, disks on that port can only be used for non-RAID applications.

In the example in figure 2.4, two SATA ports are enabled, so the non-bootable RAID array can include up to two SATA disks. If there is a disk connected to “SATA 2 Primary” or “SATA 2

Secondary”, it can not be used for RAID.

7. Press F10 to save the configuration and exit.

8. Enter the RAID BIOS Setup by pressing F10 when prompted, and proceed to set up the NVRAID BIOS as described in the next section.

21

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals