3.4 Rebuilding a RAID Mirrored Array. Shuttle SN27P2, SN27P2 V2

Add to my manuals
62 Pages

advertisement

3.4 Rebuilding a RAID Mirrored Array. Shuttle SN27P2, SN27P2 V2 | Manualzz

3.4 Rebuilding a RAID Mirrored Array

Rebuilding is the process of recovering data from one hard drive to another. All data is copied from one hard drive to another and then the data is synchronized between the two hard drives. This only applies to RAID 1 array as well as a RAID 0+1 array.

Rebuilding Instructions

After creating a mirrored array, you can rebuild the array using the following steps:

1. Go to Windows and run the NVRAID Management utility.

Figure 3.21 shows an example of a system with one mirrored array.

Figure 3.21 Mirrored Array

2. Right-click on Mirroring. The popup menu appears.

Figure 3.22 Array Pop-up Menu

45

3. From the popup menu, click Rebuild Array .

The NVIDIA Rebuild Array Wizard appears.

Figure 3.23 NVIDIA Rebuild Array Wizard

4. Click Next . The Disk Selection page appears.

46

Figure 3.24 Disk Selection Page

5. Select the drive that you want to rebuild by clicking it from the list, then click Next .

The Completing the NVIDIA Rebuild Array page appears.

Figure 3.25 Completing the NVIDIA Rebuild Array Wizard Page

6. Click Finish .

The array rebuilding starts after a few seconds, and a small pop-up message appears towards the bottom right corner of the screen as shown in Figure 3.26.

Figure 3.26 Rebuild Bubble Message

During the rebuilding process, the NVRAID Management utility screen shows the status under the System Tasks and Details sections.

Figure 3.27 Array Rebuilding Status Detail

47

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals