FCC-B Radio Frequency Interference Statement. MSI MS-1T11

Add to My manuals
36 Pages


FCC-B Radio Frequency Interference Statement. MSI MS-1T11 | Manualzz

FCC-B Radio Frequency Interference


This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and radiates radio frequency energy, and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

▶ Reorient or relocate the receiving antenna.

▶ Increase the separation between the equipment and receiver.

▶ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.


▶ The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

▶ Shield interface cables and AC power cord, if any, must be used in order to comply with the emission limits.

FCC Conditions

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

▶ This device may not cause harmful interference.

▶ This device must accept any interference received, including interference that may cause undesired operation.

CE Conformity

This device is in compliance with the essential safety requirements and other relevant provisions set out in the

European Directive.



Related manuals