Safety Instructions. MSI MS-B183

vi

Safety Instructions

◙ Read the safety instructions carefully and thoroughly�

◙ All cautions and warnings on the equipment or user’s manual should be noted�

Keep the User’s Guide that comes with the package for future reference�

Keep this equipment away from humidity and high temperature�

Lay this equipment on a reliable flat surface before setting it up.

◙ Make sure that the power voltage is within its safety range and has been adjusted properly to the value of 100~240V before connecting the equipment to the power outlet� Do not disable the protective earth pin from the plug� The equipment must be connected to an earthed mains socket-outlet�

◙

Always unplug the AC power cord before installing any add-on card or module to the equipment�

◙ Always disconnect the AC power cord or switch the wall socket off if the equipment would be left unused for a certain time to achieve zero energy consumption�

◙ Power Rating

»

65W: 100-240V~, 50-60Hz, 19V 3�42A

The ventilator on the enclosure is used for air convection and to prevent the equipment from overheating� Do not cover the ventilator�

Do not leave the equipment in an unconditioned environment with a storage temperature above 60 O C (140 O F) or below 0 O C (32 O F), which may damage the equipment�

NOTE: The maximum operating temperature is around 35 O C�

Preface

Never pour any liquid into the opening that could damage or cause electrical shock�

Place the power cord in a way that people are unlikely to step on it�

Do not place anything on the power cord�

◙ When installing the coaxial cable to the TV Tuner, it is necessary to ensure that the metal shield is reliably connected to protective earthing system of the building�

◙ Cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National Electrical Code

(NEC), in particular Section 820�93, Grounding of Outer

Conductive Shield of a Coaxial Cable�

Always keep the strong magnetic or electrical objects away from the equipment�

If any of the following situations arises, get the equipment checked by service personnel:

◙ The power cord or plug is damaged�

◙ Liquid has penetrated into the equipment�

◙ The equipment has been exposed to moisture�

◙ The equipment does not work well or you can not get it work according to user’s manual�

◙ The equipment has dropped and damaged�

◙ The equipment has obvious sign of breakage�

1� The optical storage devices are classified as CLASS 1 LASER PRODUCT.

Use of controls or adjustments or performance of procedures other than those specified is prohibited.

2� Do not touch the lens inside the drive� vii