Playback. TEAC UD-301


Add to my manuals
48 Pages

advertisement

Playback. TEAC UD-301 | Manualzz

Playback

1

Press the

¤

button to turn the unit on.

CAUTION

When using this unit (as a preamp) connected to a power amplifier, always set the LEVEL switch to VARI and minimize the volume knob before turning the amplifier on. If the connected amplifier is turned on when the LEVEL switch is set to a different setting, this could cause a sudden loud sound, resulting in damage to the speakers, harm to hearing and other trouble.

2

Press the source button to set the input source.

Press the source button repeatedly to cycle through the inputs in the following order.

USB (computer input)

COAXIAL (digital input)

OPTICAL (digital input)

The indicators light for the selected source and input sampling frequency.

o The input source indicators blink when the input signal is a digital audio signal in a format other than PCM or DSD (such as Dolby Digital, dts or AAC). If this is the case, check to see if the connected digital audio output device has a “PCM” setting for the digital output format. Refer to the operation manual for that device to make this setting.

o The sampling frequency indicators blink when there is no input signal or the input signal is not locked.

o If the sampling frequency of the input signal is 32 kHz, no sampling frequency indicator will light, but the input indicator will light.

o When using a Windows computer connected to this unit by a USB cable, you must install the dedicated

driver on that computer in order to play audio files through this unit (see page 12).

3

Start playback on the connected source device.

11

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals