N.C. Contacts, Without EOL Resistor, ATZ Series. PARADOX ESPRIT 728 ULT, 738ULT 56 Pages
N.C. Contacts, Without EOL Resistor, ATZ Series. PARADOX ESPRIT 728 ULT, 738ULT
Add to My manuals56 Pages
advertisement
738 Ultra employ two ways of wiring ATZ connections: ATZ series connections and ATZ parallel connections. The control panel will recognize the installed devices as shown in Figure 15. The extra zones function exactly like any other zone displaying zone status on the keypad and sending separate alarm codes for each zone. For more information on programming the options
mentioned in the following sections, refer to see Zone Definitions on page 25.
Figure 15: Zone Recognition with ATZ Enabled
ATZ Series Wiring (728 Ultra)
Control Panel Terminals Control Panel Terminals
ATZ Parallel Wiring (728 Ultra)
Control Panel Terminals Control Panel Terminals
ATZ Series Wiring (738 Ultra)
Control Panel Terminals Control Panel Terminals
ATZ Parallel Wiring (738 Ultra)
Control Panel Terminals Control Panel Terminals
Control Panel Terminals Control Panel Terminals
Control Panel Terminals Control Panel Terminals
2.11.1
N.C. Contacts, Without EOL Resistor, ATZ Series
If your security installation does not require tamper or wire fault recognition, but you are using the ATZ feature, connect
contacts, as this will cause the system to remain in alarm. This setup will communicate the status of each device to the control panel (see Figure 15 on page 8) and display open zones on the keypad.
Figure 16: N.C. Contacts, without EOL Resistor
Address 088 , [
MEM
] = ON (EOL resistor disabled)
[0] = OFF
Tamper/Wire Fault disabled.
[ STAY ] = OFF
Address 090 , [7] = OFF (ATZ wiring in series)
[8] = ON (ATZ enabled)
8 Reference & Installation Manual
advertisement