2. Manual Operation. TECHNIBEL MPAF240R5IAA, MPAF180R5IAA

2. Manual Operation

Operation with the Remote Control Unit (continued)

STEP 2

STEP 3

STEP 1

STEP 4

STEP 5

NOTE

Check that the circuit breaker on the power panel is turned on.

If the automatic operation settings of the unit do not meet your needs, press the setting buttons as described below and change the settings as desired.

STEP 1

STEP 2

STEP 3

Press the MODE selector button and select the desired mode.

For heating operation

For dehumidifying operation

For cooling operation

For fan only operation

→

→

→

→

(No FAN mode at M of the S/M switch on the remote control unit.)

To start the air conditioner, press the ON/OFF operation button.

Press the TEMP. setting buttons to change the temperature setting to the desired temperature.

Adjustable temperature range:

30 °C max.

16 °C min.

or 86 °F max.

60 °F min.

STEP 4 Set the FAN SPEED selector button to the setting you want.

STEP 5 Press the FLAP button and set the airflow direction as desired.

(Refer to “Adjusting the Airflow Direction” on page 21.)

To stop the air conditioner, press the ON/OFF operation button again.

13