- Home
- Domestic appliances
- Climate control
- Split-system air conditioners
- TECHNIBEL
- MPAF240R5IAA
- Operating instructions
Special Remarks. TECHNIBEL MPAF240R5IAA, MPAF180R5IAA 28 Pages
Special Remarks. TECHNIBEL MPAF240R5IAA, MPAF180R5IAA
advertisement
Special Remarks
‘‘DRY’’ ( ) Operation
How it works?
• Once the room temperature reaches the level that was set, the unit’s operation frequency is changed automatically.
• During DRY operation, the fan speed automatically runs at lower speed for providing a comfortable breeze.
• ‘‘DRY’’ operation is not possible if the indoor temperature is 15 °C or less.
Heating ( ) Operation
Heating performance • Because this air conditioner heats a room by drawing in the heat of the outside air (heat pump system), the heating efficiency will fall off when the outdoor temperature is very low. If sufficient heat cannot be obtained with this air conditioner, use another heating appliance together with it.
Defrosting • When the outdoor temperature is low, frost or ice may form on the heat exchanger coil, reducing heating performance. When this happens, a microcomputer defrosting system operates. At the same time, the fan on the indoor unit stops and the OPERATION lamp lights red and orange alternately until defrosting is completed. Heating operation restarts after several minutes. (This interval will vary slightly depending upon the outdoor temperature and the way in which frost forms.)
Cold draft prevention • For several minutes after the start of heating operation, the indoor fan runs at a lower speed until the indoor heat exchanger coil has warmed up sufficiently. However, the fan may remain stopped when the room temperature is low. This is because the COLD DRAFT PREVENTION
SYSTEM is in operation.
Cooling ( ) Operation • Sometimes the indoor unit may not get to the set fan speed such as LOW and QUIET under cool operation at very low outdoor temperatures due to the indoor unit being protected from ice or frost.
Power failure during operation
• In the event of power failure, the unit will stop. When the power is resumed, the unit will restart automatically within 5 minutes or 15 minutes at M position of the S/M switch on AUTO mode by the remote control unit.
Clicking Sound
Clicking sound is heard from the air conditioner
• In heating or cooling operation, any plastic parts may expand or shrink due to a sudden temperature change. In this event, a clicking sound may occur.
This is normal, and the sound will soon disappear.
Remote Control Unit • The remote control unit sends the setting condition signals to the air conditioner regularly at five minute intervals.
17
advertisement
Related manuals
advertisement
Table of contents
- 2 Features
- 3 Product Information
- 3 Alert Symbols
- 4 Installation Location
- 4 Electrical Requirements
- 4 Safety Instructions
- 5 Names of Parts
- 10 Using the Remote Control Unit
- 12 Operation with the Remote Control Unit
- 12 1. Automatic Operation
- 13 2. Manual Operation
- 14 3. Adjusting the Fan Speed
- 14 4. Fan Only
- 15 5. Night Setback Mode
- 16 6. QUIET Mode
- 16 7. HIGH POWER Mode
- 16 8. LED CLEAN Mode
- 17 Special Remarks
- 18 Setting the Timer
- 20 Using the 1-Hour OFF Timer
- 20 Tips for Energy Saving
- 21 Adjusting the Airflow Direction
- 22 Operation without the Remote Control Unit
- 22 Care and Cleaning
- 25 Troubleshooting
- 25 Operating Range