Settings. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV

Add to My manuals
122 Pages

advertisement

Settings. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV | Manualzz

Settings

Pos: 75.1 /Überschriften/Überschriften 1/A-E/Ei nstellungen @ 0\mod_1199868783862_78.docx @ 36141 @ 1 @ 1

10 Settings

Pos: 75.2 /BA/Sicher heit/7. Gefahrenhi nweise alt/Mähwer ke/Gefahr - R epar atur _Wartung_R einigungs_3 @ 0\mod_1196660613260_78.docx @ 9153 @ @ 1

Danger! - When performing repair, maintenance or cleaning work on the machine , or in the case of technical intervention, drive elements may start moving.

Effect: Danger to life, injuries or damage to the machine.

• Switch off the engine and remove the ignition key.

• Secure the machine against accidental start-up and against rolling!

• The cutter blades can continue to rotate after the drive has been switched off. Only approach the machine once the work tools have come to a complete standstill!

• After completing maintenance work reattach all safety devices properly.

• Avoid skin contact with oil and grease.

• Seek medical help immediately should injuries caused by oil escaping under pressure occur.

Pos: 75.3 /Überschriften/Überschriften 2/A-E/EEinstell ung der Entl astungsfedern ( 2015-10-19 15:05:29) @ 0\mod_1196666659447_78.docx @ 10133 @ 2 @ 1

10.1 Adjusting the Compensation Springs

Pos: 75.4 /BA/Sicher heit/7. Gefahrenhi nweise alt/Mähwer ke/Gefahr - Einstell ung an den Entlastungsfedern @ 0\mod_1196751594562_78.docx @ 12575 @ @ 1

Danger! - Setting on the compensation springs

Effect: Danger to life or serious injuries

• The compensation springs must only be removed in transport position. In the working position the compensation springs are subject to high tensile stress.

• Severe injury can be caused if the compensation springs are removed while in the working position.

• The lower threaded blocks on the compensation springs must be fully screwed in.

Pos: 75.5 /BA/Einstell ung en/Mähwer ke/EasyC ut/Bodendruck/Bodendruck allgemeiner T ext all e EC @ 0\mod_1196667271181_78.docx @ 10190 @ @ 1

The ground pressure for the cutter bar is adjusted to local conditions by means of the compensation springs. In order to protect the sward the load on the mowing spar must be relieved so that it does not jump when mowing, yet does not leave any skid marks on the ground.

Pos: 75.6 /Layout M odul e /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1

72

advertisement

Related manuals

advertisement

Table of contents