Pushed Design. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV

Add to My manuals
122 Pages

advertisement

Pushed Design. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV | Manualzz

Settings

Pos: 75.11 /Ü berschriften/Ü berschriften 3/F-J/GGeschobene Ausführung @ 245\mod_1395916281296_78.docx @ 1914218 @ 3 @ 1

10.2.1 Pushed Design

Pos: 75.12 /Ü berschriften/Ü berschriften 4/A-E/Bei Anbau mit Spannschloss @ 332\mod_1428906332613_78.docx @ 2541465 @ @ 1

When mounted with turnbuckle

5 2

VI

I V

I I

V

I I I

I

4 1 3

EC-534-0

Fig. 40

The ground pressure of the mower can be set via bore holes (I) to (VI) of perforated bar or via the length of the supporting chains (4).

Perforated bar:

I = high mower relief = low ground pressure

VI = low mower relief = high ground pressure

Supporting chain:

Hinged short = high mower relief = low ground pressure

Hinged long = low mower relief = high ground pressure

Pos: 75.14 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1

Setting the ground pressure:

• Turn off PTO shaft.

• Lift mower via front hydraulics of tractor.

• Switch off tractor engine, remove ignition key and carry it with you.

Via perforated bar

• Hang relief springs into one of the bore holes (I) to (IV) in the perforated bar.

Via supporting chain

• Hinge supporting chain (4) into the chain link (5) shorter or longer.

Note

If the supporting chain cannot be set so that it is shorter in the chain link and the ground pressure is still too high, the distance to the tractor can be increased by means of lower suspension arm adapters. As a result, an extended setting of the supporting chain is possible.

74

advertisement

Related manuals

advertisement

Table of contents