Blade Screw Connection. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV

Add to My manuals
122 Pages

advertisement

Blade Screw Connection. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV | Manualzz

Maintenance - Blade Changing

Pos: 111.25 /Ü berschriften/Ü berschriften 3/K- O/MMesserschr aubverschl uss @ 0\mod_1197270941296_78.docx @ 16578 @ 3 @ 1

13.2.1 Blade Screw Connection

Pos: 111.26 /BA/Wartung/M ähwer ke/M esserschr aub / M esserschnellverschluss/Beschr eibung M esser wechsel M esserschr aubverschluss @ 47\mod_1285661949953_78.docx @ 456898 @ @ 1

EC-0-250

Pic. 71

• Fold up safety device

• Clean the area

• Remove damaged or worn blades

• To fit the blades, insert the blade (5) between the wear skid (2) and the cutting disc (1)

• Insert the retaining bolt (3) from below through the wear skid, the blade and the cutting disc

• Place the locknut (4) on the retaining bolt from above and tighten it firmly (tightening torque refer to chapter “Torques”)

• Repeat the process for all blades

• After fitting the blades, fold the safety device down again

Note

• The cutter blades of anticlockwise rotating cutting discs / blade drums are different to those of clockwise rotating ones. Make certain the direction of rotation is correct when installing!

• The arrow on the cutter blades must match the direction of rotation of the corresponding cutting discs / blade drums

• The locknut (4) used to secure the retaining bolts must not be used more than once

Order No. for clockwise rotating blade: 139-889

Pos: 111.27 /Layout M odul e /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1

Order No. for anticlockwise rotating blade: 139-888

110

advertisement

Related manuals

advertisement

Table of contents