Replacing the linings. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV

Add to My manuals
122 Pages

advertisement

Replacing the linings. Krone EasyCut F 360 CV, EasyCut F 360 CR, EasyCut F 320 CV | Manualzz

Maintenance - Blade Changing

Pos: 111.31 /BA/Wartung/M ähwer ke/Stoß kanten erneuern @ 0\mod_1197271320468_78.docx @ 16636 @ 2 @ 1

13.3 Replacing the linings

Caution! - If the linings are checked irregularly.

Effect: Damage to the machine

• Always check the mowing unit for damaged linings prior to start-up and replace linings, if necessary!

• Adjust the welding current and the welding material to the cutter bar material and to the lining or carry out a trial welding if necessary.•

EC-0-012

Fig. 73

• Open the welding seams of the old lining.

• Remove the lining

• Deburr the contact surface.

Pos: 113 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1

EC-252-0

Fig. 74

• Adapt the new lining (3).

• Weld short I seams on the upper surface of the cutter bar in the areas marked (1) (each should be approx. 30 mm).

• Do not weld the edges (2).

• On the

lower surface

of the cutter bar, weld the lining (3) to the cutter bar along the whole length in area (5).

• Do not weld the edges (4).

112

advertisement

Related manuals

advertisement

Table of contents