Connecting the adapter and AC Power cord. Acer ET322QKC 30 Pages

Connecting the adapter and AC Power cord. Acer ET322QKC
Add to My manuals

Acer ET322QKC offers an immersive visual experience with its 31.5 inches WQHD display and wide viewing angles. Featuring a rapid refresh rate of 165Hz and a speedy response time of 1ms, it delivers smooth, tear-free visuals for gaming and multimedia.

advertisement

Manual
Connecting the adapter and AC Power cord. Acer ET322QKC | Manualzz

Connecting the adapter and AC Power cord

• Check first to make sure that the power cord you use is the correct type required for your area.

• The monitor has a universal power supply that allows operation in either 100/120 V AC or 220/240 V AC voltage area. No user-adjustment is required.

• Plug one end of the AC power cord to the Adapter, and plug the other end into an AC outlet.

• For units using 120 V AC:

Use a UL-listed cord set, type SVT wire and plug rated 10 A/125 V.

• For units using 220/240 V AC:

Use a cord set consisting of H05VV-F cord and plug rated 10 A/250 V. The cord set should have the appropriate safety approvals for the country in which the equipment will be installed.

LED indicator

Blue light indicates the monitor is turned on. Amber light indicates it is in power-save mode.

State LED Light

ON

Power Saving Mode

Blue

Amber

The power saving states will be kept until a control signal has been detected or the keyboard or mouse is activated. The recovery time from Active OFF state back to ON state is around

3 seconds.

Display Data Channel (DDC)

To make installation easier, so long as your system supports the DDC protocol, the monitor is able to plug-and-play. The DDC is a communication protocol through which the monitor automatically informs the host system about its capabilities; for example, supported resolutions and corresponding timing. The monitor supports the DDC2B standard.

20-pin color display signal cable

PIN No. Description

1 ML_Lane 0+

3 ML_Lane 0-

9

11

5

7

GND

ML_Lane 2+

ML_Lane 2-

GND

13

15

17

19

KONFIG1

AUX CH+

AUX CH-

Return

PIN No. Description

2 GND

4 ML_Lane 1+

10

12

6

8

ML_Lane 1-

GND

ML_Lane 3+

ML_Lane 3-

14

16

18

20

CONFIG2

GND

Hot Plug

DP_PWR

19-pin color display signal cable

PIN No. Description

1 TMDS Data2+

3 TMDS Data2-

9

11

5

7

TMDS Data1 Shield

TMDS Data0+

TMDS Data0-

TMDS Clock Shield

13

15

17

19

CEC

SCL

DDC/CEC Ground

Hot Plug Detect

PIN No. Description

2 TMDS Data2 Shield

4 TMDS Data1+

10

12

6

8

TMDS Data1-

TMDS Data0 Shield

TMDS Clock+

TMDS Clock-

14

16

18

Reserved (N.C. on device)

SDA

+5V Power

advertisement

Related manuals