Step 9, Install Duct Covers. Monogram ZV900, ZV900SLSS, ZV900SLSS
Add to my manuals20 Pages
Monogram ZV900 is a powerful and stylish 36” glass canopy chimney vent hood with four fan speeds and two halogen lights to illuminate your cooking surface. It features a 600 CFM motor to effectively remove smoke, grease, and odors from the air, while the dishwasher-safe aluminum mesh filters are easy to clean. The hood can be vented to the outdoors or recirculated within the kitchen, and it comes with everything you need for either installation.
advertisement
Installation Instructions
,167$//$7,21³5(&,5&8/$7,1*
INSTALL DUCT COVERS
• Place the decorative duct covers on top of the hood.
Mounting screw holes
NOTE:
The inside piece has holes on one end intended for use when the hood is installed for recirculating purposes.
Be sure the vented end is at the top; the vent holes will be visible in this installation.
Vent holes
The inside duct piece must slip into the folded ends on the outer section.
Duct cover support bracket
INSTALL FILTERS
IMPORTANT:
Check to be sure that the main ON/
OFF switch next to the motor is in the ON position.
Charcoal filter
• Install the black charcoal filter into the center opening. Secure the filter with thumbscrews on each side.
Metal filter
Filter Lock
Upper duct cover
Duct cover support bracket
Lower duct cover
• Tip the filter into the left or right side of the opening. Lift the filter to the opposite side and into the filter lock.
• To remove the filter, pull the filter lock downward.
FINALIZE INSTALLATION
• Remove all tape and packing material.
• Refer to the Owner’s Manual for operating instructions.
Lower duct cover seat
• Extend the inner duct upward to the ceiling bracket.
• Secure duct cover to ceiling bracket with 2 screws.
19
49-80328-3
02-13 GE
Printed in Mexico
NOTE:
While performing installations described in this book, safety glasses or goggles should be worn.
For Monogram
®
local service in your area, call
1.800.444.1845.
NOTE:
Product improvement is a continuing endeavor at
General Electric. Therefore, materials, appearance and specifications are subject to change without notice.
GE Appliances & Lighting
Appliances
General Electric Company
Louisville, KY 40225 monogram.com
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 Product Dimensions and Clearances
- 3 Installation Options
- 4 Advance Planning, Ductwork, Framing
- 4 Power Supply
- 5 Duct Fittings
- 6 Tools and Materials Required
- 6 Remove the Packaging
- 7 Determine Installation Height
- 7 Wall Mount Installation Heights
- 8 Check Installation Hardware
- 9 Ductwork, Wiring Locations
- 9 Step 1, Install Framing for Hood Support
- 10 Step 2, Install Mounting Bracket
- 10 Step 3, Install Duct Bracket
- 11 Step 4, Prepare the Hood
- 12 Step 5, Mount the Hood
- 12 Step 6, Level the Hood
- 12 Step 7, Connect Ductwork
- 13 Step 8, Connect Electrical
- 14 Step 9, Install Duct Covers
- 14 Step 10, Install Filters
- 14 Step 11, Finalize Installation
- 15 Ductwork, Wiring Locations
- 15 Step 1, Install Framing for Hood Support
- 16 Step 2, Install Mounting Bracket
- 16 Step 3, Install Duct Bracket
- 17 Step 4, Prepare the Hood
- 17 Step 5, Mount the Hood
- 17 Step 6, Level the Hood
- 18 Step 7, Size and Cut Duct Piece
- 18 Step 8, Connect Electrical
- 19 Step 9, Install Duct Covers
- 19 Step 10, Install Filters
- 19 Step 11, Finalize Installation