Setting Switching Modes. Kramer VS-88UHDA

Kramer Electronics Ltd.

Setting Switching Modes

Use the Auto Switch Settings page to set the switching mode per output.

Setting to priority or last connected mode forces VS-88UHDA to operate in AFV mode.

To set the switching mode:

1. In the Navigation pane, click Auto Switch Settings . The Auto Switch Settings page appears.

Figure 38: Auto Switch Settings Page

VS-88UHDA - Using the Embedded Web Pages 45

Kramer Electronics Ltd.

2. Select an output and set the switching mode to Manual , Priority or Last connected :



In the Manual mode (see Figure 38 ), the outputs are switched manually to the

selected output.



In the Priority mode, drag and drop the inputs from the highest to the lowest priority.

The inputs are then switched according to the set priority to the selected output:

Figure 39: Auto Switch Settings Page

– Setting the switching Priority



In the Last connected mode, select the inputs that are included in the last connected scan that will be switched to the selected output:

Figure 40: Auto Switch Settings Page

– Last Connected Mode

VS-88UHDA - Using the Embedded Web Pages 46