Default Communication Parameters. Kramer VS-88UHDA 86 Pages
advertisement
Kramer Electronics Ltd.
Technical Specifications
Inputs
Outputs
Ports
8 HDMI On female HDMI connectors
1 Stereo Analog Unbalanced Audio On 3.5mm mini jacks
8 HDMI
8 Stereo Balanced Audio
1 USB
1 RS-232
1 Ethernet
1 USB
On female HDMI connectors
On 5-pin terminal blocks (+4dBu nominal)
On a female USB-A connector
On a 3-pin terminal block for serial link extension
On an RJ-45 female connector for device control
On a female USB-A connector for powering another device
Video
Control
Power
Environmental
Conditions
Max. Resolution
Compliance
Front Panel
Consumption
Source
Operating Temperature
Storage Temperature
4K@60Hz (4:2:0) and 4K@30Hz (4:4:4)
Supports HDMI 1.4 and HDCP 1.4
Front panel buttons
7-segment display
50VA
100-240V AC, 50/60Hz
0° to +40°C (32° to 104°F)
-40° to +70°C (-40° to 158°F)
General
Humidity
Net Dimensions (W, D, H)
Shipping Dimensions (W, D, H)
10% to 90%, RH non-condensing
19", 9.3", 1U, rack mountable
52.5cm x 33cm x 10.7cm
(20.7” x 13” x 4.2”)
2.6kg (5.73lbs) approx. Net Weight
Accessories
Shipping Weight
Included
3.6 kg (7.9lbs) approx.
Rack ears, power cord
Specifications are subject to change without notice at www.kramerav.com
Default Communication Parameters
RS-232/Ethernet
Baud Rate:
Data Bits:
115,200
8
Stop Bits: 1
Example (Route input 1 to output 1):
Parity:
Command Format:
Ethernet Parameters
IP Address:
Subnet Mask:
Default Gateway:
192.168.1.39
255.255.0.0
192.168.0.1
Default TCP Port #:
Default UDP Port #:
Number of TCP ports:
Number of web clients:
Full Factory Reset
Front Panel Buttons:
Protocol 3000:
Web Pages:
None
ASCII Protocol 3000
#VID1> 1<cr>
5000
50000
8
5
Power off the device, press and hold the LOCK, EDID and STO buttons simultaneously for about 3 seconds while powering the device, and then release. Until all front panel buttons illuminate
“#factory” command.
In the Device Settings page, click Reset.
VS-88UHDA - Technical Specifications 55
advertisement