Installation. Dimplex North America Z49-00007


Add to My manuals
75 Pages

advertisement

Installation. Dimplex North America Z49-00007 | Manualzz

Installation

Site Selection for Installation

When choosing a location for the Multi-zone Wi-Fi Controller, a convenient and accessible location should be chosen. The range of the Controller is approximately

50 ft (15 m).

The Multi-zone Wi-Fi Controller can control multiple Dimplex

CONNEX TM heaters outside of the 50 ft (15 m) range, by locating heaters within 50 ft (15 m) of any other heater in the system.

installation hardware from its package.

3. Remove the support stand and compartment cover from the unit. (Figure 1 & 2)

4. Install the power cord to the unit in the provided USB connection.

5. Route the wire in the track

Figure 1

Battery Tab

Downloading the App

The Dimplex CONNEX TM App is available for your Apple or Android device.

Search

" Dimplex

CONNEX"

Figure 2

Surface Installation

1. Determine an appropriate place to locate the Multi-zone

Wi-Fi controller, in the vicinity of a 120V wall receptacle and a Wi-Fi router with an active internet connect.

2. Remove the controller and

Support Stand

7

Installation

most appropriate to your installation, and replace the compartment cover.

!

NOTE: There is a plastic tab which is associated to a back up battery to assist with the synchronization of the heaters. It is recommended that the tab remain in place until the time of synchronization. (Figure 3)

6. Adjust the support stand to have the stand open and secure. (Figure 2)

7. Reattach the support stand to the unit.

8. Plug the unit into the wall receptacle and place unit in desired location.

Wall Mount Installation

1. Determine an appropriate location to mount the Multi-zone

Wi-Fi controller, in the vicinity of a 120V wall receptacle and a Wi-Fi router with an active internet connect.

2. Remove the Multi-zone Wi-Fi

Controller and installation hardware from its package.

3. Remove the support stand and compartment cover from the unit. (Figure 1 & 2)

4. Install the power cord to the

Figure 3

Battery Tab

Figure 4

Screw Wall Anchor unit in the provided USB connection, located under the compartment cover.

5. Route the wire in the track most appropriate to your installation, and replace the compartment cover.

!

NOTE: There is a plastic tab

8 www.dimplex.com

Installation

which is associated to a back-up battery to assist with the synchronization of the heaters. It is recommended that the tab remain in place until the time of synchronization. (Figure 3)

6. Using the Wall Mounting

Bracket, mark and drill the holes for the wall anchors.

(Figure 4)

7. Install the screws through the

Wall Mounting Bracket and into the anchors.

!

NOTE: Ensure that the flat side of the Wall Mounting Bracket is against the wall and the screws are installed so that they rest against the extended portion of the hole. The space will allow screws to sit in the mounting holes correctly.

8. Slide the unit onto the screws.

9. Plug the unit into the wall receptacle.

9

advertisement

Related manuals