Edit a Memory Location. Motorola Mobility IHDT5ZX1

415A79-O 9/22/99 9:40 AM Page 24

Basic Operation

Ringer Volume

Press F and use G and H as described in the "Volume Meter" on page 23.

The maximum number of bars that will display is six.

v

– – = = ≠ ≠

Display Own Phone Number

1. Press

R

,

#

.

The phone number that is currently active will be displayed.

2. When you have finished viewing, press C .

Switch to Second Phone Number

1. Press R , # , s .

The display will go blank to confirm the switch and the newly activated number will display.

2. When you have finished viewing, press C .

Your telephone can operate over two different home systems, if you have made proper arrangements with your Cellular System Operator.

Both are designated as your "home system" but are accessed with separate telephone numbers.

While you may switch from one system to the other, only one of the two can be active at any given time. Calls are placed and received through the active system only.

24

Basic Operation

If you have two phone numbers programmed into your phone, each time the telephone is turned on, it displays a message indicating which home system type and phone number is currently active.

The message shows the system type and phone number applied, as follows:

System Type and

Phone Number

Non-wireline or A type with phone number 1

A1

Display

Non-wireline or A type with phone number 2

Wireline or B type with phone number 1

Wireline or B type with phone number 2

A2

B1

B2

If a call is placed to the inactive phone number, the caller will receive the recorded "Not In Service" message.

When you turn your phone on, the telephone will remember which system was active when you turned it off. That system will stay active until you change to the other system with the sequence R ,

# , s . However, you cannot switch systems during a call.

25