20
SG30
Documentation English
1 Documentation
The following documents describe this product:
• The data sheet describes the technical data, the dimensions, the pin assignments, the accessories and the order key.
• The mounting instructions describe the mechanical and electrical installation including all safety-relevant requirements and the associated technical specifications.
These documents can also be downloaded at " http://www.siko-global.
com/p/SG30 ".
2 Safety information
2.1 Intended use
The SG30 wire-actuated encoder is a high-precision measurement system.
The wire-actuated encoder serves exclusively for the acquisition of linear distance values. The measured values are transferred to an upstream signal as an electronic output signal.
1. Observe all safety instructions contained herein.
2. Arbitrary modifications and changes to this wire-actuated encoder are forbidden.
3. Observe the prescribed operating and installation conditions.
4. Operate the wire-actuated encoder exclusively within the scope of
technical data and the specified limits (see chapter 9 ).
SG30
Safety information English 21
DANGER
WARNING
CAUTION
NOTICE
2.2 Identification of dangers and notes
Safety notes consist of a signal sign and a signal word.
Danger classes
Immediate danger that may cause irreversible bodily harm resulting in death, property damage or unplanned device reactions if you disregard the instructions given.
Danger that may cause serious bodily harm, property damage or unplanned device reactions if you disregard the instructions given.
Danger that may cause minor injury, property damage or unplanned device reactions if you disregard the instructions given.
Important operating information that may facilitate operation or many cause unplanned device reactions if disregarded including possible property damage.
Signal signs
WARNING
2.3 Target group
Installation instructions and User manual are intended for use by the configuration, commissioning and mounting personnel of plant or machine manufacturers who possess special expertise in drive technology. This group of operators needs profound knowledge of an wire-actuated encoder's necessary connections and its integration into a complete machinery.
Insufficiently qualified personnel
Insufficiently qualified personnel cause personal injury, serious damage to machinery or wire-actuated encoder.
` Configuration, commissioning, mounting and maintenance by trained expert personnel only.
` This personnel must be able to recognize dangers that might arise from mechanical, electrical or electronic equipment.
Qualified personnel are persons who
• are familiar with the safety guidelines of the electrical and automation technologies when performing configuration tasks;
• are authorized to commission, earth and label circuits and devices/ systems in accordance with the safety standards.
