Toshiba 14.1 TFT XGA LCD MODULE - TECRA S1 (V00002008006) PC Notebook

Add to my manuals
280 Pages

advertisement

Toshiba 14.1 TFT XGA LCD MODULE - TECRA S1 (V00002008006) PC Notebook | Manualzz

80

Connecting Other External Devices

Inserting and removing hard drives

Inserting and removing hard drives

Your Tecra

®

S1 can use various hard drive capacities.

Depending upon the original hard drive installed in your computer, you may wish to increase storage capacity by changing the internal drive, or you can also add additional hard drive space by inserting a drive into the select bay module.

To change the internal hard drive.

1

Shut down your computer completely using the Shut Down command. See

“Turning off the computer” on page 62 .

2

Unplug the computer.

3

Close the display panel and remove any cables you may have connected.

4

Turn the computer upside down and remove the battery.

5

Remove the screw on the hard drive bay cover.

Removing the hard drive cover screws

6

Lift the hard drive bay cover to expose the hard drive.

7

Grasp the plastic tab on the exposed edge of the hard drive and pull it to remove the hard drive from the computer.

5.375 x 8.375 ver 2.3

Connecting Other External Devices

Inserting and removing hard drives

81

Removing the hard drive from the computer

8

Pull the clips off of the old hard drive and remove the cover.

Removing the cover

9

Snap the cover onto the new hard drive.

Snapping the cover onto the new hard drive

10

Install the new hard drive by sliding it into the hard drive bay and pressing it firmly until it locks. Do not force the drive into the computer.

5.375 x 8.375 ver 2.3

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Download PDF

advertisement

Table of contents