Power Trim/Tilt Switch. TOHATSU BFT 115A, BFT 150A
advertisement
36ZX1T120_EN.book Page 21 Tuesday, November 28, 2017 4:48 PM
CONTROLS AND FEATURES
Power Trim/Tilt Switch
Power Trim
Press the power trim/tilt switch on the remote control lever to adjust the outboard motor trim angle of – 4° to
16° to maintain proper boat trim. The power trim/tilt switch can be operated while the boat is under way or while stopped.
By using the power trim/tilt switch the operator can change the trim angle of the outboard motor to achieve maximum boat acceleration, speed, stability and maintain optimum fuel consumption.
(R1 type)
(R3 type)
(SINGLE TYPE)
POWER TRIM/
TILT SWITCH
POWER TRIM/
TILT SWITCH REMOTE CONTROL
LEVER
(R2 type)
POWER TRIM/TILT SWITCH
REMOTE CONTROL LEVER
(DUAL TYPE)
REMOTE
CONTROL
LEVER
POWER TRIM/TILT SWITCH
(LEFT) (RIGHT)
The outboard motor trim angle of
– 4° to 16° is the angle when the outboard motor is installed on the boat at 12°.
REMOTE
CONTROL
LEVER
Excessive trim/tilt angle during operation can cause the propeller to raise out of the water and cause propeller ventilation and engine over-revving. Excessive trim/tilt angle can also damage the water pump.
21
advertisement