Outboard Motor Installation. TOHATSU BFT 115A, BFT 150A

36ZX1T120_EN.book Page 33 Tuesday, November 28, 2017 4:48 PM

INSTALLATION

Outboard Motor Installation

BOLT (4)

WASHER (4)

Standard torque:

55 N·m (5.6 kgf·m, 41 lbf·ft)

The standard torque is given just as a guideline. Torque of the nut can be different according to the material of the boat. Consult with an authorized

TOHATSU outboard motor dealer.

NUT (8)

WASHER (8)

STERN

BRACKET

1. Apply the silicone sealant (Three

Bond 1216 or equivalent) to the outboard motor mounting holes.

2. Set the outboard motor on the boat and secure with the bolts, washers, and lock nuts.

LIFTING

EYES (3)

Install the outboard motor securely. Loosely mounted outboard motor can result in accidental loss of the outboard motor and damage and injury to the equipment and personnel.

Before installing the outboard motor on the boat, hang the outboard motor with the hoist or equivalent devise by attaching the three lifting eyes to the outboard motor.

Use the hoist which allowable load is

250 kg (551 lbs) or above.