Remote Control Box Location. TOHATSU BFT 115A, BFT 150A
advertisement
36ZX1T120_EN.book Page 38 Tuesday, November 28, 2017 4:48 PM
INSTALLATION
Remote Control Cable Length
<Remote Control Box Location>
REMOTE CONTROL LEVER
REMOTE
CONTROL BOX
REMOTE
CONTROL
CABLE
Remote Control Box Location
<Remote Control Cable Length>
Do not bend the remote control cable as sharp as its route diameter is 300 mm (11.8 in) or less, or it affects the service life of the cable and the remote control lever operation.
Install the remote control box in the position where is easy to operate the remote control lever and switches.
Be sure that there are no obstacles on the route of the control cable.
The control box position of the R2 type and the R3 type should be determined in the same manner.
Measure the distance from the control box to the outboard motor along the cable routing.
Recommended cable length is
300 – 450 mm (11.8 – 17.7 in) longer than the measured distance.
Set the cable along the predetermined route and be sure that it is long enough to the route.
Connect the cable to the engine and be sure it is not kinked, bent sharp, pulled taut, or interfered while steering.
38
advertisement