6. PRE-OPERATION CHECKS. TOHATSU BFT 115A, BFT 150A
advertisement
36ZX1T120_EN.book Page 40 Tuesday, November 28, 2017 4:48 PM
6. PRE-OPERATION CHECKS
BFT115A/150A is 4-stroke, water cooled outboard motor which uses unleaded regular gasoline for fuel. It also requires the engine oil. Check the following before operating the outboard motor.
Engine Cover Removal/Installation
ENGINE COVER
Perform the following pre-operation checks with the engine stopped.
Before each use, look around and underneath the engine for signs of oil or gasoline leaks.
ENGINE COVER LATCH
• To remove, pull the engine cover latch and lift the engine cover straight up.
• To install, place the engine cover on the outboard motor, and push down evenly.
When reinstalling the covers, make sure not to jam the wire harnesses in between the covers and engine case.
Do not operate the outboard motor without the engine cover.
Exposed moving parts can cause injury.
40
advertisement