- Vehicles & accessories
- Motor vehicle accessories & components
- Engine
- TOHATSU
- BFT 150A
- Owner's manual
- 130 Pages
GASOLINE CONTAINING ALCOHOL. TOHATSU BFT 115A, BFT 150A
advertisement
Assistant Bot
Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.
36ZX1T120_EN.book Page 44 Tuesday, November 28, 2017 4:48 PM
PRE-OPERATION CHECKS
Gasoline is extremely flammable and is explosive under certain conditions.
• Refuel in a well-ventilated area with the engine stopped.
• Do not smoke or allow flames or sparks in the area where the engine is refueled or where gasoline is stored.
• Do not overfill the fuel tank
(there should be no fuel in the filler neck). After refueling, make sure the fuel filler cap is closed properly and securely.
• Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite. If any fuel is spilled, make sure the area is dry before starting the engine.
• Avoid repeated or prolonged contact with skin or breathing of vapor.
KEEP OUT OF REACH OF
CHILDREN.
44
GASOLINE CONTAINING
ALCOHOL
If you decide to use a gasoline containing alcohol (gasohol), be sure its octane rating is at least as high as that recommended by TOHATSU.
There are two types of “gasohol”: one containing ethanol, and the other containing methanol.
Do not use gasohol that contains more than 10% ethanol.
Do not use gasoline containing more than 5% methanol (methyl or wood alcohol) and that does not also contain co-solvents and corrosion inhibitors for methanol.
• Fuel system damage or engine performance problems resulting from the use of gasoline that contains more alcohol than recommended is not covered under the warranty.
• Before buying gasoline from an unfamiliar station, first determine if the gasoline contains alcohol, if it does, find out the type and percentage of alcohol used.
If you notice any undesirable operating symptoms while using a particular gasoline. Switch to a gasoline that you know contains less than the recommended amount of alcohol.
advertisement
Related manuals
advertisement
Table of contents
- 8 1. SAFETY
- 8 SAFETY INFORMATION
- 10 2. SAFETY LABEL LOCATIONS
- 12 3. COMPONENT IDENTIFICATION
- 16 4. CONTROLS AND FEATURES
- 16 Remote Control Lever
- 16 R1 type
- 17 R2 type
- 18 R3 type
- 19 Neutral Release Lever
- 19 Engine Switch
- 20 Fast Idle Lever/Fast Idle Button
- 21 PGM-FI Indicator/Buzzer
- 21 ACG Indicator/Buzzer
- 22 Oil Pressure Indicator/Buzzer
- 22 Overheat Indicator/Buzzer
- 22 Water Separator Buzzer
- 23 Power Trim/Tilt Switch
- 24 Trim Meter (optional equipment)
- 24 Power Tilt Switch (outboard motor pan)
- 25 TRL (Trolling) Control Switch
- 25 Manual Relief Valve
- 26 Emergency Stop Switch
- 26 Emergency Stop Switch Lanyard/Clip
- 27 Spare Emergency Stop Switch Clip (optional equipment)
- 28 Tilt Lock Lever
- 28 Trim Tab
- 28 Anode
- 29 Cooling Water Check Hole
- 29 Cooling Water Intake Port
- 29 Engine Cover Latch
- 30 Tachometer (optional equipment)
- 30 NMEA Interface Coupler
- 30 Operating Hour Notification System
- 33 5. INSTALLATION
- 33 Transom Height
- 34 Location
- 34 Installation Height
- 35 Outboard Motor Installation
- 36 Outboard Motor Angle Inspection (Cruising)
- 37 Battery Connections
- 39 Remote Control Installation (optional equipment)
- 40 Remote Control Box Location
- 40 Remote Control Cable Length
- 41 Propeller Selection
- 41 Fuel Line Connection
- 42 6. PRE-OPERATION CHECKS
- 42 Engine Cover Removal/Installation
- 43 Engine Oil
- 46 GASOLINE CONTAINING ALCOHOL
- 47 Propeller and Cotter Pin Inspection
- 48 Remote Control Lever Friction
- 48 Water Separator
- 49 Battery
- 50 Other Checks
- 51 7. STARTING THE ENGINE
- 51 Fuel Priming
- 51 Starting the Engine
- 51 R1 type
- 55 R2, R3 types
- 59 8. OPERATION
- 59 Break-in Procedure
- 60 Gear Shifting
- 60 R1 type
- 61 R2 type
- 62 R3 type
- 63 Cruising
- 65 TRL (Trolling) Control Switch
- 66 Trimming the Outboard Motor
- 68 Trim Meter (optional equipment)
- 69 Tilting the Outboard Motor
- 70 Moorage
- 71 Power Tilt Switch (outboard motor pan)
- 72 Manual Relief Valve
- 73 Trim Tab Adjustment
- 74 Engine Protection System
- 74 PGM-FI and ACG Warning Systems
- 78 Over-rev Limiter
- 78 Anodes
- 78 Shallow Water Operation
- 79 Multiple Outboard Motors
- 80 9. STOPPING THE ENGINE
- 80 Emergency Engine Stop
- 80 Normal Engine Stop
- 82 10. TRANSPORTING
- 82 Fuel Line Disconnection
- 82 Transporting
- 83 Trailering
- 84 11. CLEANING AND FLUSHING
- 85 12. MAINTENANCE
- 86 Tool Kit and Owner’s Manual
- 86 Spare Emergency Stop Switch Clip (optional equipment)
- 87 Maintenance Schedule
- 89 Engine Oil
- 91 Spark Plugs
- 96 Lubrication
- 98 Fuel Filter
- 101 Water Separator
- 103 EMISSION CONTROL SYSTEM
- 104 Battery
- 107 Main Fuse
- 107 ACG Fuse
- 108 Propeller
- 109 Submerged Outboard Motor
- 111 13. STORAGE
- 111 Vapor Separator Draining
- 112 Engine Oil
- 113 Battery Storage
- 114 Outboard Motor Position
- 115 14. DISPOSAL
- 116 15. TROUBLESHOOTING
- 118 16. SPECIFICATIONS
- 121 CONTENT OUTLINE
- 126 18. INDEX