- Vehicles & accessories
- Motor vehicle accessories & components
- Engine
- TOHATSU
- BFT 150A
- Owner's manual
- 130 Pages
Battery. TOHATSU BFT 115A, BFT 150A
advertisement
Assistant Bot
Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.
36ZX1T120_EN.book Page 47 Tuesday, November 28, 2017 4:48 PM
Battery
Battery handling differs according to the type of the battery and the instructions described below might not be applicable to the battery of your outboard. Refer to the battery manufacturer’s instructions.
Battery Inspection
Check whether the battery fluid is between the upper and lower levels, and check the vent hole in the battery caps for clogging.
If the battery fluid is near or below the lower level, add the distilled water to the upper level (see page
102).
Check that the battery cables are connected securely.
If the battery terminals are contaminated or corroded, remove the battery and clean the terminals
(see page 103).
POSITIVE (+)
TERMINAL
UPPER
LEVEL
LOWER
LEVEL
Batteries produce explosive gases: If ignited, an explosion can cause serious injury or blindness.
Provide adequate ventilation when charging.
• CHEMICAL HAZARD: Battery electrolyte contains sulfuric acid.
Contact with eyes or skin, even through clothing, may cause severe burns. Wear a faceshield and protective clothing.
PRE-OPERATION CHECKS
• Keep flames and sparks away, and do not smoke in the area.
ANTIDOTE: If electrolyte gets into your eyes, flush thoroughly with warm water for at least 15 minutes and call a physician immediately.
• POISON: Electrolyte is poison.
ANTIDOTE:
─ External: Flush thoroughly with water.
─ Internal: Drink large quantities of water or milk.
Follow with milk of magnesia or vegetable oil, and call a physician immediately.
• KEEP OUT OF REACH OF
CHILDREN.
47
advertisement
Related manuals
advertisement
Table of contents
- 8 1. SAFETY
- 8 SAFETY INFORMATION
- 10 2. SAFETY LABEL LOCATIONS
- 12 3. COMPONENT IDENTIFICATION
- 16 4. CONTROLS AND FEATURES
- 16 Remote Control Lever
- 16 R1 type
- 17 R2 type
- 18 R3 type
- 19 Neutral Release Lever
- 19 Engine Switch
- 20 Fast Idle Lever/Fast Idle Button
- 21 PGM-FI Indicator/Buzzer
- 21 ACG Indicator/Buzzer
- 22 Oil Pressure Indicator/Buzzer
- 22 Overheat Indicator/Buzzer
- 22 Water Separator Buzzer
- 23 Power Trim/Tilt Switch
- 24 Trim Meter (optional equipment)
- 24 Power Tilt Switch (outboard motor pan)
- 25 TRL (Trolling) Control Switch
- 25 Manual Relief Valve
- 26 Emergency Stop Switch
- 26 Emergency Stop Switch Lanyard/Clip
- 27 Spare Emergency Stop Switch Clip (optional equipment)
- 28 Tilt Lock Lever
- 28 Trim Tab
- 28 Anode
- 29 Cooling Water Check Hole
- 29 Cooling Water Intake Port
- 29 Engine Cover Latch
- 30 Tachometer (optional equipment)
- 30 NMEA Interface Coupler
- 30 Operating Hour Notification System
- 33 5. INSTALLATION
- 33 Transom Height
- 34 Location
- 34 Installation Height
- 35 Outboard Motor Installation
- 36 Outboard Motor Angle Inspection (Cruising)
- 37 Battery Connections
- 39 Remote Control Installation (optional equipment)
- 40 Remote Control Box Location
- 40 Remote Control Cable Length
- 41 Propeller Selection
- 41 Fuel Line Connection
- 42 6. PRE-OPERATION CHECKS
- 42 Engine Cover Removal/Installation
- 43 Engine Oil
- 46 GASOLINE CONTAINING ALCOHOL
- 47 Propeller and Cotter Pin Inspection
- 48 Remote Control Lever Friction
- 48 Water Separator
- 49 Battery
- 50 Other Checks
- 51 7. STARTING THE ENGINE
- 51 Fuel Priming
- 51 Starting the Engine
- 51 R1 type
- 55 R2, R3 types
- 59 8. OPERATION
- 59 Break-in Procedure
- 60 Gear Shifting
- 60 R1 type
- 61 R2 type
- 62 R3 type
- 63 Cruising
- 65 TRL (Trolling) Control Switch
- 66 Trimming the Outboard Motor
- 68 Trim Meter (optional equipment)
- 69 Tilting the Outboard Motor
- 70 Moorage
- 71 Power Tilt Switch (outboard motor pan)
- 72 Manual Relief Valve
- 73 Trim Tab Adjustment
- 74 Engine Protection System
- 74 PGM-FI and ACG Warning Systems
- 78 Over-rev Limiter
- 78 Anodes
- 78 Shallow Water Operation
- 79 Multiple Outboard Motors
- 80 9. STOPPING THE ENGINE
- 80 Emergency Engine Stop
- 80 Normal Engine Stop
- 82 10. TRANSPORTING
- 82 Fuel Line Disconnection
- 82 Transporting
- 83 Trailering
- 84 11. CLEANING AND FLUSHING
- 85 12. MAINTENANCE
- 86 Tool Kit and Owner’s Manual
- 86 Spare Emergency Stop Switch Clip (optional equipment)
- 87 Maintenance Schedule
- 89 Engine Oil
- 91 Spark Plugs
- 96 Lubrication
- 98 Fuel Filter
- 101 Water Separator
- 103 EMISSION CONTROL SYSTEM
- 104 Battery
- 107 Main Fuse
- 107 ACG Fuse
- 108 Propeller
- 109 Submerged Outboard Motor
- 111 13. STORAGE
- 111 Vapor Separator Draining
- 112 Engine Oil
- 113 Battery Storage
- 114 Outboard Motor Position
- 115 14. DISPOSAL
- 116 15. TROUBLESHOOTING
- 118 16. SPECIFICATIONS
- 121 CONTENT OUTLINE
- 126 18. INDEX