Trim Meter (optional equipment). TOHATSU BFT 115A, BFT 150A

36ZX1T120_EN.book Page 66 Tuesday, November 28, 2017 4:48 PM

OPERATION

Trim Meter

(optional equipment)

The trim meter indicates the trim angle of the outboard motor. Refer to the trim meter, and press the UP or

DN (down) portion of the power trim/ tilt switch to adjust the outboard motor trim angle to achieve boat performance and stability.

The illustration represents R1 type.

Perform the same procedure for the other types.

BOW TOO LOW DUE TO

1. LOAD IN THE FRONT

2. OUTBOARD MOTOR TRIMMED

TOO LOW

BOW TOO HIGH DUE TO

1. LOAD IN THE REAR

2. OUTBOARD MOTOR TRIMMED

TOO HIGH

With the outboard motor trimmed low the trim meter will read as shown. To raise the bow increase the outboard motor trim angle by pressing the UP portion of the power trim/tilt switch.

With the outboard motor trimmed high the trim meter will read as shown. To lower the bow decrease the outboard motor trim angle by pressing the DN (down) portion of the power trim/tilt switch.