Engine Oil. TOHATSU BFT 115A, BFT 150A
advertisement
36ZX1T120_EN.book Page 87 Tuesday, November 28, 2017 4:48 PM
MAINTENANCE
Engine Oil
Insufficient or contaminated engine oil adversely affects the service life of the sliding and moving parts.
Oil capacity:
6.5 L (6.9 US qt, 5.7 Imp qt)
…when oil filter is not replaced
6.7 L (7.1 US qt, 5.9 Imp qt)
…when oil filter is replaced
Recommended Oil:
SAE 10W-30 engine oil or equivalent, API Service category SG,
SH or SJ.
<Engine Oil Change>
OIL FILLER CAP
Drain the oil while the engine is still warm to assure rapid and complete draining.
1. Position the outboard motor vertically, and remove the engine cover. Remove the oil filler cap.
DRAIN PLUG COVER
LEVER
2. Push the drain plug cover lever and remove the cover while pulling the cover backward at an angle.
87
36ZX1T120_EN.book Page 88 Tuesday, November 28, 2017 4:48 PM
MAINTENANCE
DRAIN PLUG COVER
GUIDE
DRAIN PLUG COVER
GUIDE
3. Set the drain plug cover under the guide.
88
SEALING WASHER
DRAIN BOLT
GUIDE
UPPER
LEVEL
MARK
DRAIN
PLUG
COVER
OIL LEVEL DIPSTICK
LOWER
LEVEL
MARK
4. Place a suitable container under the guide.
5. Remove the engine oil drain bolt and sealing washer using the 12 mm wrench and drain the engine oil.
Install a new sealing washer and drain bolt, and tighten bolt securely.
DRAIN BOLT TIGHTENING
TORQUE:
23 N·m (2.3 kgf·m , 17 lbf·ft)
6. Refill to the upper level mark on the oil level dipstick with the recommended oil.
7. Install the dipstick securely.
advertisement